Connecting The Dvg-1402S In Front Of A Router - D-Link DVG-1402S User Manual

Getting Started (continued)
Connecting the DVG-1402S in Front of a
Router
If you wish to connect your DVG-1402S in front of a router, follow the steps
below. After the steps are completed, your setup should look similar to the
diagram below. This is the recommended method for setting up the DVG-1402S.
This set up allows the DVG-1402S to prioritize voice traffic over data traffic,
thus providing you with greater consistency and call quality.
1. Turn off your Computer.
2. Disconnect the power to the Cable/DSL Modem (unplug or turn off the power
switch).
3. Disconnect the power to your existing router (unplug or turn off the power
switch).
4. Unplug the existing Cat 5 Ethernet cable from the "WAN" port of your existing
Router.
5. Leave the other end of this cable attached to your Cable/DSL Modem.
13