Connecting Power
Power is supplied to the 10/100 Fast Ethernet Switch through an
AC power cord. The AC power input voltage ranges from 100 to
240 VAC. A power cable is included with the device.
Figure 6 Connecting Power
Network Connections
If any port on the 10/100 Fast Ethernet Switch is set for full-
duplex operation, the device (or LAN) connected to that port
should also be set for full-duplex operation. The following sections
discuss the requirements for each operating mode.
10/100Mbps Ports
Port 1 and port 2 are variable-speed ports and require Category 5
unshielded twisted-pair or shielded twisted-pair (UTP/STP) cable
to run at 100Mbps. The attached station must be within 100
meters of the 10/100 Fast Ethernet Switch. When connecting a
18
Installation