D-Link Express EtherNetwork DI-604 Quick Installation Manual page 2

Connecting The DI-604 Broadband Router
To Your Network
A. First, connect the power adapter to the receptor at the back panel of the
DI-604 and then plug the other end of the power adapter to a wall outlet or
power strip. The Power LED will turn ON to indicate proper operation.
B. 1. Power off your Cable or DSL modem; some devices may not have a on/off
switch and will require you to unplug the power adapter. Now, the DI-604
should be powered on and the Cable / DSL modem should be turned off.
2. Cable / DSL modem
Connect an Ethernet cable to the Ethernet jack located on the Cable / DSL
modem. After the Ethernet cable is securely connected, power on the Cable /
DSL modem by turning on the unit or plugging in the power adapter.
3. Cable / DSL modem
Insert the other end of the Ethernet cable to the WAN PORT on the back
panel of the DI-604. The WAN LED light will illuminate to indicate proper
connection. If the WAN LED is not illuminated, please go back and step B and
repeat its instructions.
C. Insert an Ethernet cable to LAN port 1 on the back panel of the DI-604 and an
available Ethernet port on the network adapter in the computer you will use to
configure the DI-604. The LED light for LAN Port 1 will illuminate to indicate
proper connection. (Note: The LAN Ports on the DI-604 are Auto-MDI/MDIX.
Meaning you can use a straight-through or crossover-Ethernet cable to the
LAN Ports.)
B. WAN Port
This is the connection for the
Ethernet Cable to Ethernet Port on
the Cable or DSL Modem.
C. LAN Ports
These are the connections for Ethernet
cables to your Ethernet-enabled computers
(Power Off) – DI-604 (Power
(Power On) – DI-604 (Power
On)
On)
Reset Button
Pressing this button
restores the router
to its original factory
default settings.
A. Receptor for
Power Adapter