Yamaha SYSTEM72 Owner's Manual

Electric Acoustic Guitar
SYSTEM72
Owner's Manual
Thank you for choosing a Yamaha electric-acoustic guitar.
In order to make the most of the advanced features and performance provided by your guitar,
please read this manual carefully before using the instrument.
Note that this manual covers only the electronic parts of this product. For information on the
other non-electronic parts, refer to the separate Acoustic Guitar Owner's Manual.
PRECAUTIONS
PLEASE READ CAREFULLY BEFORE PROCEEDING
Please keep this manual in a safe and handy place for future reference.
WARNING
Always follow the basic precautions listed below to avoid the possibility of serious injury
or even death from electrical shock, short-circuiting, damages, fire or other hazards. These
precautions include, but are not limited to, the following:
Do not open
Water warning
If you notice any abnormality
CAUTION
Always follow the basic precautions listed below to avoid the possibility of physical injury to
you or others, or damage to the instrument or other property. These precautions include, but
are not limited to, the following:
Connection
Location
Handling caution
* Yamaha cannot be held responsible for damage caused by improper use or modifications
to the instrument, or data that is lost or destroyed.
* Information on the battery can be found in the section at the end of this sheet.
* Please read the instruction manual for the external audio device such as a guitar
amplifier, etc., prior to use.
Replacing the Batteries
q Slide the tab on the endpin section in the direction indicated by the arrow in the diagram
below to release the lock, then pull out the battery holder.
w Insert two AA batteries making sure that the battery poles are properly aligned with the
polarity markings on the battery holder.
e Slide the battery holder back into the endpin section until it locks.
q
Release the lock
Battery Holder
System72_ZW19200_R0_0706.indd 2
EN
Tab
AA battery
x2
Nomenclature / Controls
Control Section
The built-in preamplifier is automatically turned ON when a guitar
cable is connected to the output jack. Always set the volume to its
minimum level when connecting or disconnecting the cable.
q VOL Control
Controls the volume.
w BATT. (Battery Check) Indicator
This indicator will light when the battery needs to be replaced. Please replace the
battery as soon as possible when the BATT. indicator lights.
* The battery check indicator may light momentarily when the TUNER switch is
pressed. This is not a sign however, that the battery power is low.
e 3-Band Equalizer
LOW : Boosts or cuts the level of the low frequencies.
MID : Boosts or cuts the level of the middle frequencies. The AMF control r adjusts
the center frequency of the band affected by this control.
HIGH : Boosts or cuts the level of the high frequencies.
r AMF Control
Sets the center frequency of the band of frequencies affected by the MID equalizer
control. The range is from 80 Hz to 10 kHz.
* This control has no effect when the MID equalizer control is set to its center position.
t Tuner Display
Displays tuner information.
y TUNER Switch
Switches the tuner ON/OFF.
u Sound Hole Cover (included)
Inserting the sound hole cover into the sound hole effectively reduces feedback.
Using The Tuner
q Press and hold the TUNER switch until the
power ON.
w Tune the guitar string until the note name of the desired pitch appears in the display.
e The string is in tune when only the
lamp lights in the center of the
J J J
Pitch is low In Tune
r Press the TUNER switch again to switch the tuner power OFF. Also, if the note name is not
shown in the display for more than 1 minute, the power will automatically switch OFF.
( display goes off)
* It may take a few seconds before the tuner can detect pitches after being switched ON.
* The note name and GLVSOD\V PD\ KDYH GLI¿FXOW\ NHHSLQJ XS ZLWK LUUHJXODU
pitch changes. Gradually change the pitch and check when tuning.
* The tuner may not be able to detect notes rich with overtones or with very short sustain.
* Sound output is not muted when the tuner is being used.
Specifications
● System: ● Pickup:
System72 Bar Sensor (Piezo type)
VOL, 3-Band EQ (HIGH, MID, LOW), AMF control, TUNER
● Output Impedance:
power switch 1kΩ
● Battery Life:
Approx. 180 hours (When tuner is not used and when alkaline batteries are
installed)
* May differ depending on operating conditions.
(12 semi-tones), Accuracy range +/– 3 cents, A4=440Hz
hex-wrench x1, Sound hole cover x1
7KH FRQWHQWV RI WKLV PDQXDO DSSO\ WR WKH ODWHVW VSHFL¿FDWLRQV DV RI WKH SXEOLVKLQJ GDWH
7R REWDLQ WKH ODWHVW PDQXDO DFFHVV WKH <DPDKD ZHEVLWH WKHQ GRZQORDG WKH PDQXDO ¿OH
Pickup Section
Output Jack (with power switch function)/
Battery Holder
display lights to switch the tuner
display.
I I I
Pitch is high
● Preamplifier Controls:
● Output Jack:
Combination end pin/
● Batteries:
Size AA alkaline battery (LR6) x2
● Tuner:
Chromatic type
● Accessories:
Neck adjustment
2016/9/2 15:04:10