Table of Contents
Advertisement
• Clean the filter after each drying
cycle.
• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
• Use the condensate as distilled water,
e.g. for steam ironing. If it is necessary
clean the condensate before (e.g.
with a coffee filter) to remove possible
small pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Make sure that is good airflow in the
appliance installation position.
10.2 Adjustment of the
remaining laundry moisture
degree
To change the default degree of the
remaining moisture of the laundry:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold
down the Dry Plus and Anti-crease
buttons.
One of the symbols goes into the view
on the display:
- the maximum dry laundry
- the more dry laundry
11. CARE AND CLEANING
11.1 Cleaning the filter
At the end of each cycle the symbol
Filter is on the display and you must
clean the filter.
The filter collects the fluff.
The fluff occurs while the
clothes are dried in the
tumble dryer.
To clean the filter:
1. Open the door. Pull the filter.
- the standard dry laundry
5. Push the Start/Pause button again
and again until you set necessary
degree.
6. To memorise the setting, push at the
same time the Dry Plus and Anti-
crease buttons for approximately 2
seconds.
10.3 Deactivating the Water
container indicator
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold
down the Dry Plus and Buzzer
buttons.
One of 2 configurations is possible:
• the Water container indicator:
is on and the symbol
goes into the view - the water
container indicator is permanently
on
• the Water container indicator:
is off and the symbol
goes into the view - the water
container indicator is permanently
off
2. Open the filter.
ENGLISH
17
Advertisement
Table of Contents
