Makita 6827 Instruction Manual page 5

Reversing switch action
1
A
B
This tool has a reversing switch to change the direction of
rotation. Move the reversing switch lever to the
tion (A side) for clockwise rotation or the
side) for counterclockwise rotation.
CAUTION:
• Always check the direction of rotation before opera-
tion.
• Use the reversing switch only after the tool comes
to a complete stop. Changing the direction of rota-
tion before the tool stops may damage the tool.
Adjusting the fastening torque
1
When you wish to drive machine screws, wood screws,
hex bolts, etc. with the predetermined torque, adjust the
fastening torque as follows.
The fastening torque may be adjusted by turning the
adjusting ring. Before turning the adjusting ring, turn the
locator in the direction of the arrow as far as it will go
without forcing. The torque is increased by turning the
adjusting ring in the direction of the arrow and decreased
by turning it in the opposite direction. Align the number 1
on the adjusting ring with the pointer on the gear hous-
ing. Drive a trial screw into your material or a piece of
duplicate material. If the fastening torque is not suitable
for the screw, continue adjusting until the proper torque is
obtained.
CAUTION:
• The adjusting ring should be turned only within the
numbered range. It should not be forced beyond
this range.
002635
1. Reversing
switch lever
position (B
002642
1. Locator
2 3
2. Adjusting ring
3. Pointer
Hook
The hook is convenient for temporarily hanging the tool.
When using the hook, pull it out in A direction and then
push it in B direction to secure in place.
When not using the hook, return it back to its initial posi-
tion by following the above procedures in reverse.
A
posi-
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing the bit
To remove the bit, first pull the front cap off and then pull
the bit out firmly.
To install the bit, insert it into the tool as far as it will go
and then replace the front cap.
5
002646
1. Hook
1
002647
B
002655