Table of Contents
Advertisement
using your kettle
If this kettle is filled above the maximum level mark, hot water may be ejected
from the spout during boiling. Beware of steam coming from the spout or lid
especially during refilling. Never open the lid when the kettle is boiling. The Filter
and filter funnel must be fitted to the kettle in order for it to operate correctly.
1. With the kettle switched off, plug the power base into a suitable power outlet.
2. Remove the kettle from the power base before filling it with water. Do not fill the kettle
through the spout.
3. Open the lid and fill the kettle with water. Don't overfill the kettle and always
ensure that there is sufficient water in the kettle for it to operate correctly. This is
approximately 250ml or 1 teacup full. Always check the water level when the kettle
is positioned on its power base. Allow a short time after filling for the water to pass
through the filter.
4. Close the lid and then switch the kettle on. Make sure that the lid is closed correctly
to ensure safe operation.
5.
When the kettle is switched on, the switch and the water level window will illuminate.
6. When the water reaches boiling point, the kettle will switch off automatically. The
water level window illumination will switch off.
7. You may also switch the kettle off manually at any time by moving the switch to the
off position.
Always use caution when carrying your kettle when it is full of boiling water and when
pouring it.
Energy saving hints and tips
A Breville
kettle, if used correctly, is a very energy efficient device. Why not try some of
®
these energy saving tips:
•
Only boil the water you need. Overfilling your kettle by one cup is the equivalent to
using an energy saving light bulb for one hour!
•
It is not always necessary to re-boil your kettle. For example, one litre of water will
still be at 90°C after five minutes - the perfect temperature for a cup of coffee.
If the kettle boils dry
If the kettle is operated with insufficient water a built in fail-safe device will automatically
switch off the kettle.
•
Unplug the kettle and allow it to cool. When the kettle has cooled down sufficiently
the device will reset itself.
•
Once the device has reset, refill the kettle with cold water and use it as normal.
8
Advertisement
Table of Contents
