Table of Contents
Advertisement
18
www.aeg.com
1. Pull the water container out keeping
it in a horizontal position.
2. Pull the plastic connection out and
drain the water into a basin or
equivalent receptacle.
3. Push the plastic connection back in
and place the water container back
into position.
4. To continue the programme press
the Start/Pause button.
11.3 Cleaning the condenser
If the Condenser indicator flashes,
inspect the condenser and its
compartment. If it is dirty, clean it.
WARNING!
Do not touch the metal
surface with bare hands. Risk
of injury. Wear protective
gloves. Clean carefully to do
not damage the metal
surface.
To inspect:
1. Open the door. Pull the filter up.
2. Slide the release button on the
bottom of the door to open the
condenser door.
3. Turn the lever to unlock the
condenser cover.
4. Lower the condenser cover.
5. If necessary, remove the fluff from
the heat exchanger and its
compartment. You can use a wet
cloth and/or a vacuum cleaner with a
brush attachment.
Advertisement
Table of Contents
