Black & Decker BDS303 User Manual page 7

- Walls covered with metal
- Very humid conditions
- Shielded cables
Before use, always test the tool by detecting a known pipe or wire.

If in doubt contact a qualified service agent.

Warning! This tool will not detect wires in circuits isolated from the mains supply, cables
operating at direct current (DC) or wires used for telecommunication or computer systems.
Hidden wires (e.g. wall lights) may not be detected when switches are in the off position.
Warning! This tool will not detect pipes of any other material than metal.
Labels on tool
The following pictograms are shown on the tool:
Warning! To reduce the risk of injury, the user must read the instruction manual.
Features
1. On/off switch
2. Mode selector switch
3. LCD screen (stud/metal finder)
4. LED indicator (AC wire)
Assembly
Fitting the battery (fig. A)
Slide the battery cover (4) off the tool.

Insert the battery making sure to match (+) and (-) terminals inside the battery

compartment with the battery.
Refit the cover and let it click into place.

Use
Note:
Keep fingers away from the area of detection as this may interfere with the results.

The wall must be flat to get the most accurate results.

Selecting the operating mode
Set the mode selector switch (2) to the

position for the detection of wooden studs.
ENGLISH
7