Makita LC05 Instruction Manual page 5

power receptacle. The battery power lamp
lights up and start charging. Charging takes
approximately 3 hours. The light goes out
after the charging is complete. For more
details, refer to the instruction manual of
battery charger.
Switch action
CAUTION:
Always be sure that the dust bag or
•
paper pack is installed properly in the
cleaner before
installation may allow dust to enter the
motor, resulting in malfunction of the
cleaner.
Always switch off the cleaner after
•
each use to prevent damage to the
cleaner and to extend the service life of
the batteries.
014725
To start the cleaner, simply press the
"1/2/3" button. To switch off, press the "0"
button. To change the cleaner speed, press
the "1/2/3" button. The first press on this
button is for high speed and the second
press for low speed. Each press on this
button repeats the high/low speed cycle
alternatively.
While pressing the "1/2/3" button, this
cleaner works with turbo. This mode is
appropriate to clean especially dusty area.
use. Improper
1. Switch buttons
1
Battery power lamp
014723
When the remaining battery capacity gets
low, the battery power lamp blinks.
When the remaining battery capacity gets
much lower, the tool stops and the battery
power lamp lights up about 10 seconds. At
this time, charge the cleaner.
NOTE:
The time at which the battery power
•
lamp start blinking or lighting up
depends on the temperature at work
place and
conditions.
ASSEMBLY
Disposing of Dust
CAUTION:
Empty the cleaner before it becomes
•
too full, or the suction force weakens.
Be sure to empty out the dust inside
•
the cleaner itself. Failure to do so may
cause the sponge filter to be clogged
or the motor to be damaged.
Never throw away the dust stopper
•
because it should be used whenever
either the dust bag or the dust pack is
used.
1. Push the button to open the front
cover. Opening it until a click is heard
allows a positive stop at that position.
5
1. Battery power
lamp
1
the battery cartridge