Mounting The Tv On The Wall; Removing The Stand; Handling And Precautions With The Wall-Mounted Tv - Sharp Aquos LC-40LB700X Operation Manual

Appendix

Mounting the TV on the wall

Removing the stand

For wall mounting with the optional bracket, remove the stand.
Before detaching/attaching the stand
• Before detaching (or attaching) the stand, unplug the AC cord from the AC outlet.
• Remove all terminal covers and connected cables.
• Lay the TV down on cushioning (such as a blanket) over a table.
• Make sure two or more people perform the operation.
CAUTION
• Do not remove the stand from the TV unless using an optional bracket to mount it.
1
Unfasten the four screws used to secure the stand in
place.
NOTE
• To attach the stand, perform the above steps in reverse order.

Handling and precautions with the wall-mounted TV

• You can mount the TV on the wall using the optional AN-37AG2 bracket and AN-37P30 attachment.
• For details, refer to the instructions supplied with the optional bracket.
CAUTION
• This TV should be mounted on the wall only with the AN-37AG2 (SHARP) / AN-37P30 (SHARP) wall mount bracket.
The use of other wall mount brackets may result in an unstable installation and may cause serious injuries.
• Installing the Liquid Crystal Television requires special skill that should only be performed by qualifi ed service
personnel. Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper
mounting or mounting that results in accident or injury.
Using an optional bracket to mount the TV
• You can ask a qualifi ed service personnel about using an optional AN-37AG2 bracket and AN-37P30 attachment to mount
the TV to the wall.
• Carefully read the instructions that come with the bracket before beginning work.
Hanging on the wall
AN-37AG2/AN-37P30 wall mount bracket.
(See the bracket instructions for details.)
Vertical mounting
CAUTION
• Install the TV vertically on the wall. If the TV is installed at an angle, the Disc Drive may not operate normally.
NOTE
• Detach the cable clamps on the rear of the TV when using the optional mount bracket.
• To use this TV mounted on a wall, fi rst remove the cover at the 4 locations on the rear of the TV, and then use the screws
supplied with the wall mount bracket to secure the bracket to the rear of the TV.
LC-40LB700X_en_j.indd 93 LC-40LB700X_en_j.indd 93
2
Screw
driver (not
supplied)
1 Detach the stand from the TV. (Hold the stand so
it will not drop from the edge of the base area.)
2 Remove the stand post from the stand base and
attach it to the TV.
About setting the TV angle
Stand post
• Refer to the operation manual
of AN-37AG2 e AN-37P30 for
details.
8/7/2009 5:26:45 PM 8/7/2009 5:26:45 PM
93