Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Makita LXDT03
Summary of Contents for Makita LXDT03
- Page 1 INSTRUCTION MANUAL Cordless Impact Driver LXDT03 LXDT04 012011...
-
Page 2: Specifications
ENGLISH (Original instructions) SPECIFICATIONS Model LXDT03 LXDT04 Machine screw 4 mm - 8 mm (5/32" - 5/16") Capacities Standard bolt 5 mm - 14 mm (3/16" - 9/16") High tensile bolt 5 mm - 12 mm (3/16" - 1/2") No load speed (RPM) - Page 3 13. Remove any adjusting key or wrench before Battery tool use and care turning the power tool on. A wrench or a key left 24. Recharge only with the charger specified by attached to a rotating part of the power tool may the manufacturer.
- Page 4 USD302-1 Tips for maintaining maximum battery life Symbols Charge battery cartridge before completely discharged. The followings show the symbols used for tool. ･ Always stop tool operation and charge the volts battery cartridge when you notice less tool ･ power. direct current Never recharge...
-
Page 5: Functional Description
At this time, release the switch trigger, FUNCTIONAL DESCRIPTION remove the battery cartridge and remove causes of overload and then pull the switch trigger again to restart. CAUTION: When battery cells get hot: Always be sure that the tool is switched off and the •... - Page 6 NOTE: 1. Bit Use a dry cloth to wipe the dirt off the lens of lamp. • 2. Sleeve Be careful not to scratch the lens of lamp, or it may lower the illumination. Reversing switch action 1. Reversing switch lever 012009 To install the bit, insert the bit into the sleeve as far as it will go.
-
Page 7: Operation
Hold the tool firmly and place the point of the driver bit in OPERATION the screw head. Apply forward pressure to the tool to the extent that the bit will not slip off the screw and turn the tool on to start operation. NOTE: Use the proper bit for the head of the screw/bolt •... - Page 8 1 minute. Then check the tool while running and electric brake operation when releasing the switch trigger. 012019 If electric brake is not working well, ask your local Makita Raise the arm part of the spring and then place it in the service center for repair.
-
Page 9: Optional Accessories
Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Screw bits • Hook • Plastic carrying case •...