Makita 9902 Instruction Manual page 8

MAINTENANCE
1. Limit mark
1
2
1. Brush holder cap
2. Screwdriver
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended for use with your Makita tool specified in this manual. The
use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Makita service center.
• Abrasive belts
• Sanding shoe
• Dust bag
Makita Corporation Anjo, Aichi, Japan
884285D220
CAUTION:
• Always be sure that the tool is switched off and unplugged before
attempting to perform inspection or maintenance.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly. Replace them when they are
worn down to the limit mark. Keep the carbon brushes clean and free to slip in
the holders. Both carbon brushes should be replaced at the same time. Use
only identical carbon brushes.
1
Use a screwdriver to remove the brush holder caps. Take out the worn carbon
003396
brushes, insert the new ones and secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs, any other mainte-
nance or adjustment should be performed by Makita Authorized Service Cent-
ers, always using Makita replacement parts.
• Hose 28 mm in inner diameter
• Belt sander stand