AEG BSS 4802 Instruction Manual page 34

English
34
First Use of the Device/Introduction
NOTE:
The buttons on the device are touch buttons. Touch the
keys lightly with a finger to perform the function.
• Select a proper place for the device. A dry, level and slip
proof surface is suitable.
• Make sure the device is vented sufficiently!
• Remove the protective film from the device, if present.
Power supply
• Insert the grid plug into a properly installed three prong
socket with 230 V, 50 Hz. Connect the device with the
plug connector by inserting its plug into the DC 12 V jack
of the device.
• Make sure the grid voltage corresponds to the figures on
the rating plate.
CAUTION:
• The included AC adapter may only be used with this
device. Do not use it for other devices.
• Use only an AC adapter with 12 V (
AC adapter may damage the unit.
NOTE:
• Disconnect from mains power supply during longer
periods of non-use.
• The time and the stored radio stations are lost as soon
as the power supply has been interrupted.
Setting the clock (during standby mode)
1. Briefly hold down the TIME/MEM button (10). The hour
indicator starts to flash.
2. Use UP/DN buttons to set the hours. Confirm with TIME/
MEM.
3. Use UP/DN buttons to set the minutes.
4. Press TIME/MEM again in order to save the time settings.
NOTE:
If nothing is entered within approx. 6 seconds, the device
reverts back to the normal display.
General Operation
Switch device on/off
• With the STANDBY button (9), you can switch the unit
between standby and operating mode. The time is
displayed in standby mode.
• To disconnect the unit completely from the mains, pull
the mains plug from the socket.
NOTE:
• The time and the stored radio stations are lost as soon
as the power supply has been interrupted.
NOTE:
• After 10 minutes without a signal, the device switches
to standby automatically.
Volume
By pressing the VOL+/VOL- buttons (5) you can adjust the
desired volume.
Sound Settings
If necessary, change the EQ setting in your playback unit to
create the best sound.
Display brightness
When the display is in standby, you can set the brightness of
the display by repeatedly pressing the SLEEP button (11).
Radio mode
Search for a radio station
1. Fully uncoil the wire antenna.
2. You have two options in order to search for a radio sta-
). A different
tion:
• Adjust the desired radio station using the UP or DN
button (14).
• Keep the UP or DN button pressed down for a short
while. The device will stop at the next radio station.
3. If the reception is too weak and there is interference on
the received station, try to improve the reception by alter-
ing the position and uncoiling or coiling the antenna.
Storing radio stations
1. Search for a radio station as described under "Search for
a radio station".
2. Press the TIME/MEM button (10). The display will start to
flash.
3. Using the UP/DN buttons (14) select the memory location
where the radio station is to be stored.
4. Press the TIME/MEM button again. The radio station will
be stored and the display will stop flashing.
NOTE:
The stored radio stations are lost as soon as the power sup-
ply has been interrupted.
Select the preset radio station
You can select the stored radio sender with the ALARM/M+
and M- buttons (7/6).
Playing back music files
You have three options to play back your own music files with
the unit: hardwired, wireless via Bluetooth, or via the USB
port.