Rinse Aid - Baumatic BDW45.1 Instruction Manual

BAUMATIC BDW45.1

RINSE AID

• TO OPEN THE DISPENSER, TURN THE CAP TO
THE 'OPEN' (LEFT) ARROW AND LIFT IT OUT.
• POUR THE RINSE AID INTO THE DISPENSER.
BE CAREFUL NOT TO OVERFILL.
• REPLACE CAP BY INSERTING IT ALIGNED WITH
'OPEN' ARROW & TURN IT TO THE CLOSED
(RIGHT) ARROW.
• THE RINSE AID IS RELEASED DURING THE
ADJUSTING THE RINSE AID DISPENSER
• As with detergent, the amount of rinse
aid needed for your dishes depends on
the hardness of the water in your area.
Too much rinse aid can result in foaming
and cause cloudiness or streaks on your
dishes. If your water is very soft, you
may not need rinse aid. You can always
dilute the rinse aid with an equal
The rinse aid dispenser has six settings. ALWAYS START WITH THE DISPENSER SET ON "1". IF SPOTS & POOR
DRYING ARE A PROBLEM, INCREASE THE AMOUNT OF RINSE AID DISPENSED BY REMOVING THE DISPENSER LID
AND ROTATING THE DIAL TO "2". IF THE DISHES ARE STILL NOT DRYING PROPERLY OR ARE SPOTTED, ADJUST
THE DIAL TO THE NEXT HIGHER NUMBER UNTIL YOUR DISHES ARE SPOT-FREE.
NOTE: Please read the notes for detergent use on p. 13.
***
WHEN TO REFILL THE RINSE
AID DISPENSER
aid warning light ( control panel) is not on, you
SEE
can judge the rinse aid level by looking at the
black dot on the rinse aid dispenser. As the rinse
aid level decreases, the black dot shrinks. Never
let the rinse aid get below ¼ full.
dishwasher user manual
amount of water.
-
If the rinse
7
FINAL RINSE TO PREVENT WATER FROM
FORMING DROPLETS ON YOUR DISHES THAT
CAN CAUSE SPOTS AND STREAKS. IT ALSO
IMPROVES DRYING BY ALLOWING WATER TO
• YOUR DISHWASHER IS DESIGNED TO USE
LIQUID RINSE AIDS. THE RINSE AID
DISPENSER CAN BE FOUND INSIDE THE
DOOR NEXT TO THE DETERGENT DISPENSER.
TO FILL THE DISPENSER, OPEN THE CAP AND
POUR THE RINSE AID INTO THE DISPENSER
UNTIL THE LEVEL INDICATOR TURNS
COMPLETELY BLACK. THE DISPENSER
HOLDS ABOUT 100ML OF LIQUID RINSE AID.
• BE CAREFUL NOT TO OVERFILL THE
DISPENSER – THIS COULD CAUSE FROTHING.
WIPE AWAY SPILLS WITH A DAMP CLOTH.
DON'T FORGET TO REPLACE THE CAP
BEFORE YOU CLOSE THE DISHWASHER
NOTE: IF YOU HAVE SOFT WATER, YOU MAY NOT
NEED RINSE AID FOR IT MAY CAUSE A WHITE FILM TO
DEVELOP ON YOUR DISHES.
As the rinse aid diminishes, the size of the black dot on the rinse
aid level indicator changes, as illustrated below.
Full
3 / 4 full
1 / 2 full
1 / 4 full - Should refill to eliminate spotting
Empty
7
FALL OFF THE DISHES.
DOOR.