Operation; Switching On And Off; Switching Off Automatically; Face Mask - Silvercrest SGS 100 A1 Operating Instructions Manual

BB*5$B*HVLFKWVVDXQDB%ERRN 6HLWH  'RQQHUVWDJ  -XOL    
NOTES:
• Please add oils one drop at a time to a
cotton wool pad and place the same
into the aroma reservoir 4.
• If you are not sure about the effect of the
herbs or oils (stinging eyes etc.), ask a
pharmacist before first use.
3. Place the nose mask 2 with its aperture
pointing toward the front onto the aro-
ma reservoir 4.
4. Connect the mains plug 10 with a wall
socket. The on/off switch 7 is set to 0.

7. Operation

The heat and moisture of the steam opens
the pores and thus provides for a better re-
moval of any impurities. Using the facial
sauna you prepare your skin optimally for
further applications, such as for example
face masks or deep cleansing. Naturally, the
use of the facial sauna is also simply just fan-
tastically relaxing.
DANGER! Risk of injury
through burning/scalding
~ The water is boiling in the water con-
tainer 5 during operation. Any contact
with boiling water or hot steam may
cause serious injury. Use the device
only with one of the two attachments 1
or 2.
NOTE: what to do when you are not
feeling well
~ If you do not feel well during the use of
the facial sauna or your breathing be-
comes restricted in any way (shortness
of breath), stop using the device imme-
diately and switch the device off.

7.1 Switching on and off

By turning the on/off switch /steam flow
rate controller 7 you switch the device on
and off and control the steam quantity in two
stages.
- 0: device is switched off
- 1: lower steam quantity
- 2: higher steam quantity (only for
use with the face mask)
7.2 Switching off
automatically
For safety reasons the device switches off au-
tomatically if the water in the water contain-
er 5 has evaporated. Before the device can
then be switched back on again, the mains
plug 10 must be disconnected once and
then re-connected.

7.3 Face mask

1. Prepare the face mask as described
(see "Assembly" on page 42).
2. Switch the on/off switch/steam flow
rate controller 7 to I or 2. The LED 8
lights up.
3. Figure C: after approx. 2-3 minutes,
steam is generated. Hold your face into
the face mask. Close your eyes and en-
joy the beneficial effect of the steam.
4. Figure E: the steam quantity can also
be set by means of the manual steam
flow rate controller 11. For more
steam, you push the controller into the
direction MAX, for less steam you
push the controller into the direction
MIN.
NOTE: the deeper you hold your face into
the face mask, the more intensive the effect
of the steam will be. If this becomes too
much for you, take your head a little out of
the face mask.
43
GB