Advertisement
Quick Links
Installing a Jaton Video Card in VORTEK™
®
GLOBAL VR
is now shipping the Jaton 3DForce2 MX-64DDR video card as a replacement part
for use in VORTEK cabinets. This video card requires drivers that are supplied on the Invasion
Earth Game Software CD, or a separate VORTEK video driver CD. Follow the steps in this
document to install the video card and drivers. Install video drivers only from disks supplied by
GLOBAL VR.
Important: Only install GLOBAL VR approved video cards in GLOBAL VR games. The games
will not run properly with other video cards.
Safety
Please read this page before beginning the service procedure.
Tools Required
• Medium (#2) Philips Screwdriver
• Grounding Wrist Strap (for ESD Protection)
Page
of
1
6
© 2006 Global VR, Inc. All Rights Reserved. VORTEK, GLOBAL VR, and the GLOBAL VR logo are trademarks or registered trademarks of
Global VR, Inc. All other trademarks are the properties of their respective owners.
Document Part #: 040-0117-01
To avoid electrical shock, disconnect the AC power cord before
beginning any service or installation procedures.
GLOBAL VR assumes no liability for any damages or injuries incurred
while setting up or servicing the cabinet. Only qualified service
personnel should perform installation or service procedures!
To prevent electrostatic discharge (ESD) damage, handle PCBs by the
edges only and use a grounding wrist strap or similar precaution.
Figure 1.
Jaton 3DForce2 MX-64DDR Video Card
4/27/2006
Advertisement
Related Manuals for Jaton 3DForce2 MX-64DDR
Summary of Contents for Jaton 3DForce2 MX-64DDR
- Page 1 ® GLOBAL VR is now shipping the Jaton 3DForce2 MX-64DDR video card as a replacement part for use in VORTEK cabinets. This video card requires drivers that are supplied on the Invasion Earth Game Software CD, or a separate VORTEK video driver CD. Follow the steps in this document to install the video card and drivers.
- Page 2 Installing a Jaton Video Card in VORTEK Determine your Computer Type GLOBAL VR has used Graphite and DFI computers for the VORTEK system. The pictures below show the general appearance of the connector panel of the DFI and Graphite Computers. The Graphite computer has the CD-ROM drive on the same side as the connectors. The DFI computer has the CD-ROM drive on the front panel and connectors on the back.
- Page 3 Installing a Jaton Video Card in VORTEK 5. Your computer may be secured to the cabinet with brackets, or with a strap and buckle, as shown in the picture below. Loosen the strap, or remove the wood screws that secure the brackets to the cabinet, and carefully lift the computer out of the cabinet.
- Page 4 Installing a Jaton Video Card in VORTEK 7. Locate the existing video card in the AGP slot in the computer. 8. Use a medium (#2) Philips screwdriver to remove the chassis screw that secures the video card, as shown by the arrow in the third part of the picture below.
- Page 5 Running the System Disk with the Jaton Card If you need to restore the operating system with the System Disk on a system with a Jaton video card, you must follow the steps below to re-install the Jaton video drivers before installing the games.
-
Page 6: Tech Support Information
Installing a Jaton Video Card in VORTEK Note: If the computer does not boot from the CD (the game starts), connect a keyboard and do the following to make sure CDROM is set as the first boot device in the BIOS settings: •...