Honeywell Code Encryptor II Installation Manual page 17

Hide thumbs Also See for Code Encryptor II:

Table of Contents

DSC 1550 and Caddx 8980E

• DSC 1550 or Caddx 8980E panels work differently than other panels. When

either of the two alarm systems are armed they automatically arm in the STAY or

BYPASS mode until an entry/exit zone is tripped.

• Because of this panel set up, the Code Encryptor II has provisions to overcome this

problem.

If you are using one of these two panels follow the instructions below.

Step 1) Verify that the Code Encryptor II recognizes the alarm system as a Caddx

8980E or a DSC 1550 (see page 5)

Step 2) Use the Channel 3 relay wires to bypass the zone.

Every time the Code Encryptor II is armed in the Away mode, the relay will energize

for 1 full second to open or close the Entry/Exit zone. If the customer is already

outside the house when the panel is armed, the relay will trigger that zone

automatically to move the panel from BYPASS to Away mode.

Alarm Panel

Zone programmed

as an entry/exit

Channel 3 wires offer N/O and N/C contacts.

Utilize the wires to open or close the zone based on your installation.

Black

Red

Brown

CODE

ENCRYPTOR

Brown/White

Table of Contents