Sfc Convergence Correction (Kv-36Hq100) - Sony KV-32HQ100B Service Manual

TLH Adjustment (KV-32HQ100)
THL Correction assy
TLH correction can be performed by adding a THL correction
assembly to the Deflection yoke.
YCH Adjustment (KV-32HQ100)
+
+
+
YCH VR
Deflection Yoke
TLV Adjustment (KV-32HQ100)
TLV VR
+
+ +
Deflection Yoke
H-TRAP Adjustment (KV-32HQ100)
+
+ +
HTRAP VR
Deflection Yoke
The H-TRAP should not be adjusted unless absolutely necessary as it
affects the TLV settings.
3-4.

SFC Convergence Correction (KV-36HQ100)

1. Use TT Commander to Obtain TT55
2. SFC Menu & Crosshatch pattern will appear. Press button'2'
to toggle to Convergence mode. Menu will appear as;
CONV
COAR
HCV 00
VCV 00
3. To adjust Convergence, choose Coarse or Fine mode by
toggling button '9'.
COARSE MODE ADJUSTABLE LOCATION
*In Coarse Mode, all data will change equally for that particular
column area.
FINE MODE ADJUSTABLE LOCATION
*In Fine Mode, data will change for that position only.
4. Use commander arrows to move flashing location cursor to
required position for adjustment.
5. Choose required location by using arrow up, down, right,
left on commander to move location cursor.
(Cursor will start in centre position)
6. Once location is chosen, press 'OK' once, cross hatch pattern
will remain and HCV and VCV will be adjustable., location
cursor will not flash.
7. Toggle commander arrows left and right to adjust HCV, up
and down arrows to adjust VCV. Text colour buttons can be
pressed to check each colour if necessary. If mis-convergence
has disappeared, press 'OK' once more, cursor will start to
flash.
8. If required, re-select another location for adjustment and
repeat steps 5) to 7).
9. Once all adjustment is complete, press 'Mute' key to Exit
SFC Test mode.
- 25 -
Convergence Mode
Coarse or Fine mode
Horizontal Convergence data
Vertical Convergence data
Location cursor (flashing)