Settings; Operation - Husqvarna Automower Connect 2G Operator's Manual

Display and change the settings of the product
from everywhere in the world. For security
reasons you must use short-range
communication (Bluetooth
General and Security settings, or disable the
®
Automower Connect module on the product.
3.1 To set the GeoFence center
The GeoFence function makes it possible to
monitor the product, for example in case of
theft. Before GeoFence can be used, its
center point and sensitivity must be set. This
can only be done from the menu in the
product.
1. Put the product in the center of the work
area.
2. Select Accessories > Automower
Connect .
3. Enter the PIN code.
GeoFence .
4. Select
Activate GeoFence and push OK.
5. Select
New center point to set the source
6. Select
for GeoFence.
GeoFence sensitivity can be changed.
Sensitivity can be set to
The higher the sensitivity, the easier the alarm
is activated.
4.1 Main menu
Dashboard : Shows the current status of
•
the product. It shows symbols for the
battery status and cutting height.
Map : Shows the current position of the
•
product and the set centerpoint for
GeoFence. You can monitor the
movement of the product with this
function, for example in case of theft.
Messages (only available for Bluetooth
•
short-range connectivity): In this menu the
1438 - 002 - 17.01.2020

3 Settings

®
) if you change
®
Low, Medium or High .

4 Operation

®
Note:
When you put the product into storage
for a long period, it is recommended to switch
off the main switch to save battery power. With
the GeoFence function on, a PIN code is
necessary to switch off the product. If you
switch off the main switch, the Automower
Connect stays on for 12 hours. After that it is
not possible to communicate with the product
and the GeoFence function is not on.
3.2 Symbols on the display
These symbols are shown on the display of
the product when Automower
enabled.
The signal strength of the GPRS
reception.
Problem with the connection to the
Internet server.
Problem with the SIM card or the
module.
fault and information messages can be
found. For some of the messages, there
is information to help you to correct the
fault.
4.2 My mowers
My mowers shows the status of the product,
you can remove or add products paired to the
account.
®
®
Connect is
Settings - 3