Maintenance; Lamp Replacement; Lamp Replace - Canon LV-S3 Owner's Manual

Maintenance

Lamp Replacement

Lamp Replace

When the life of the projection lamp draws to an end, LAMP
REPLACE indicator lights yellow. If this indicator lights yellow,
replace the projection lamp with a new one promptly.
Allow a projector to cool, for at least 45 minutes before
you open Lamp Cover. The inside of a projector can
become very hot.
Follow these steps to replace the lamp assembly.
1 Turn off the projector and disconnect AC plug. Allow the
projector to cool at least for 45 minutes.
2 To remove the lamp cover, remove the screw with a screwdriver .
3 Remove the two screws with a screwdriver and pull out the
lamp assembly by grasping the handle.
4 Replace the lamp assembly with a new one and tighten the two
screws back into the position. Make sure that the lamp
assembly is set properly. Replace the lamp cover and tighten
the screw.
5 Connect the AC Power Cord to the projector and turn on the
projector.
6 Reset the Lamp Replace Counter.
Refer to "Lamp Replace Counter" on the next page .
Note :
Do not reset the Lamp Replace Counter when the projection lamp has not
been replaced.
ORDER REPLACEMENT LAMP
Replacement Lamp can be ordered through your dealer. When ordering a projection lamp, give the following
information to the dealer.
Model No. of your projector
•
Replacement Lamp Type No.
•
40
VOL +
This indicator lights yellow when the
life of the projection lamp draws to an
end.
CAUTION
For continued safety, replace with a lamp assembly of
the same type.
Do not drop a lamp assembly or touch a glass bulb! The
glass can shatter and may cause injury.
Screws
: LV-S3
: LV-LP20
(610 308 3117)
TOP CONTROL
SET MENU
LAMP
REPLACE WARN
Screw
Lamp Cover
Handle
Lamp Assembly