Making Adjustments; Adjustment (Imagepress C1Series, Imagepress C7000Series); Adjusting The Right Angle (Imagepress C1Series, Imagepress C7000Series) - Canon DADF-R1 Service Manual

Chapter 2

2.3 Making Adjustments

2.3.1 Adjustment (imagePRESS
C1Series, imagePRESS
C7000Series)
When the machine has properly been installed,
perform the following in sequence:
[1] Adjusting the Right Angle
[2] Horizontal Registration Adjustment
[3] Leading Edge Registration Adjustment
[4] Horizontal Registration Adjustment (Fine
Adjustment)
[5] Leading Edge Registration Adjustment (Fine
Adjustment for Both Sides)
2.3.2 Adjusting the Right Angle
(imagePRESS C1Series,
imagePRESS C7000Series)
Here, the original feed direction of the machine is
adjusted in relation to the optical system of the host
machine.
1) Prepare a test chart as shown using A4 or LTR
copy paper.
10mm
Right angle
F-2-60
2-18
2) Place the test chart [1] prepared above in the
original tray, and make a copy in stream reading
mode at 100% magnification.
0013-0255
3) Place other copy paper [2] on the image [1] you
obtained in step 2), and check the image for right
angles.
- A < 1 mm
- B < 1 mm
0013-0259
[1]
10mm
If not as indicated, go through the following:
4) Open the DADF.
[1]
F-2-61
[2]
Feed
direction
Feed
direction
F-2-62