Operational Notes - Honeywell PENA D MLS2000SSP Installation And Commissioning Instructions

GB
Tips
I. When there are only two options such as ON/OFF, a double click
of the OK button toggles between them.
II. Where there are multiple options, a double click of the OK button
recalls a list of all options for that parameter. Use the UP, DOWN
and OK buttons to select the desired alternative.
III. Use the OK button to go forward (through the menus)
without displaying HELP pages.
IV. Press the UPLOAD button at any time to transfer all current
settings from the D HP2000 to the panel.
Please refer to the D HP2000 Instructions for comprehensive
commissioning details.
Notes
The panel is capable of recognising zone numbers from 1 to 50 and
can be programmed to belong to up to four of these. In addition it
can be programmed to belong to up to three Common Zones.

Operational Notes

The ON button calls up the panel's programmed Entry Scene. The
system may also be activated by a quick press on any scene button,
bringing that scene on. All luminaires directly controlled by the
panel and those linked by zone but controlled by other devices will
respond.
The OFF button switches off all luminaires controlled directly by
the panel and those linked by zone but controlled by other devices.
Temporary Override raises the light level of all luminaires
controlled directly by the panel and those linked by zone but
controlled by other devices.
Temporary Override dims the light level of all luminaires
controlled directly by the panel and those linked by zone but
controlled by other devices.
When the temporary Override buttons have been used the LED of
the latest scene selected will flash to indicate that the panel is no
longer outputting a pre-set scene light level. The panel will remain
in this state until it receives a new command from the Keypad, the
MLS bus or an Infrared Remote Control device, or time-out occurs.
PEHA Lichtsteuerung – PEHA Elektro GmbH & Co. KG a Honeywell Company · Gartenstraße 49 · 58511 Lüdenscheid · Deutschland · www.peha.de · peha@peha.de
Setting and Recalling Scenes
To set a scene, select the required scene and adjust to the desired
light level using the buttons of the panel itself, or those of
the D HC5 Infrared Remote Control, or the Utility functions of the
D HP2000. When the level is reached, it must be „learned" by the
panel as the new value for that scene.
This can only be done by sending the appropriate scene select
signal continuously over a period of six seconds via the Infrared
Remote Control link from an D HC5 or an D HP2000. With the
device correctly aligned to the panel, press and hold the required
scene select key until the luminaires under the direct control of the
panel begin to flash on and off slowly. The LED of the scene button
in question should flash during this process and be lit constantly
at the end of this operation.
To recall a pre-set scene simply press the appropriate button briefly.
The LED of the button in question should be lit at the end of this
operation. This operation can also be carried out remotely using
the scene select buttons of the D HC5.
Scene Responses
1 The panel signals to detectors linked by zone to enter Scene
1 regulating mode but will continue to output the previously
commanded level to its directly controlled luminaires.
2-6 The panel signals to detectors linked by zone and its own output
to enter the relevant scene as previoulsy programmed.
W4368D_DE_1204 Seite 6/7