Operation - Craftsman CMEBL700 Operator's Manual

the power head (figure F) by locating the assembly as indicated by
arrow, then pivot about this point until the locking/release catch is
fully engaged.
SHOULDER COLLECTION BAG (FIGURE G)
NOTE: Ensure the vacuum is switched
off and disconnected from the power
supply before attaching or removing the
collection bag.
• Remove blower tube if attached.
• Attach the shoulder collection bag to
the power head as shown in figure G.
REMOVING BLOW TUBE, VAC TUBE OR
COLLECTION BAG (FIGURES H)
• To remove the blow tube, vac tube or
shoulder collection bag,
depress the release button on the power
head and pull straight off (figure H).

OPERATION

ALWAYS WEAR SAFETY GLASSES. WEAR A FILTER MASK IF
THE OPERATION IS DUSTY. USE OF RUBBER GLOVES AND
SUBSTANTIAL FOOTWEAR IS RECOMMENDED WHEN WORKING
OUTDOORS. FOR HOUSEHOLD USE ONLY.
Use blower/vac only in daylight or good artificial light.
SWITCHING ON AND OFF (FIGURE I)
WARNING:
USE BOTH HANDS TO GRIP THE PRODUCT
FIRMLY WHEN SWITCHING ON.
CAUTION:
DO NOT POINT UNIT DISCHARGE AT SELF
OR BYSTANDERS.
seconds after it has been switched off. Use
both hands to grip the tool and let the motor come
to a complete stop before setting the tool down.
Your blower vac is fitted with a two speed
switch located on the top of the power head
G
below the handle.
• To use in low speed, rotate on/off switch
• To turn tool OFF, rotate on/off switch (1) counterclockwise to the off
EXTENSION CORD RETAINER FIGURE J)
H A cord retention hook is
incorporated into the rear of
the power head.
• To use the cord retainer
as shown in figure J, hook
the extension cord under the
retainer. Then plug the cord
from the power head into the
extension cord.
• To use the cord retainer as
shown in figure J, loop the extension cord over the power head cord and
plug the two ends into each other. Then hook the extension cord under
the retainer.
operation is dusty. Use of gloves, long pants and substantial footwear
is recommended. Keep long hair and loose clothing away from
openings and moving parts. THIS BLOWER IS FOR HOUSEHOLD
6
WARNING:
The tool will continue to run for approximately 5
(1) clockwise to Position "I". To use in high
speed, rotate on/off switch (2) clockwise to
Position "Il".
position "0".
BLOWER OPERATION
CAUTION:
Always wear safety glasses. Wear a filter mask if the
I
J