■ NOTE: The WLE-POE-S Supply Adapter must be used with a compatible AirStation or POE Receiver when supplying power to the AirStation. Check the specifications on Page 4 to verify compatibility. Package Contents: POE Supply Adapter ◗ ◗ Power Supply Cable ◗...
POE- compatible AirStation Supplying Power to non-POE-compatible AirStations ◗ Connect the hub or PC to the LAN port of the WLE-POE-S Power Supply Adapter. ◗ Connect CAT5 cable between the POE ports of the WLE-POE-S Power Supply Adapter and the WLE-POE-R33/R7 Receiver Adapter.
Page 3
* WLE-POE-R7 (For 7v AirStation Products) ■ NOTE: The WLE-POE-S Power Supply Adapter uses the IEEE802.3af standard and injects 48V over the CAT5 cable. The WLE-POE-S Power Supply Adapter can be used with IEEE802.3af POE Receiver Adapters. However, it is recommended to always use the WLE-POE-R33 or WLE-POE-R7 POE Receiver Adapters in conjunction with Buffalo AirStation products.
Specifications Transmission Rate Connector POE Port LAN Port Input Power Supply (AC) Output Power (POE) Maximum Output Current Maximum Current Consumption Operating Environment Dimensions (mm) Weight 100 Mbps (100BASE-TX) 10 Mbps (10BASE-T) RJ-45 modular connector 100BASE-TX / 10BASE-T dual purpose port (for connecting the POE Receiver Adapter) 100BASE-TX / 10BASE-T dual purpose port (for connecting a hub or PC)
◗ All rights for this setup guide are owned by Buffalo INC. No part of it may be transmitted, reproduced, or revised without expressed permission from BUFFALO INC.