Operation; Start Cooking; Cleaning, Care And Maintenance - Buffalo FB861 Instruction Manual

Table of Contents

Advertisement

UK

Operation

Note: Before first time use, wipe clean the interior surfaces and let dry well.

Start Cooking

1. Connect the appliance to the mains power supply.
2. Place food in the oven and close the door.
3. Set cooking time using the time knob. The corresponding time indicator(s) will light up and the
appliance will start automatically.
4. When cooking time elapses, the appliance will beep 5 seconds then enter Standby mode.
5. The fan will continue to run for 1 minute to cool the appliance, then switch off automatically.
Note: If the door is opened during cooking, the oven will stop and switch to
Standby mode at once. The cooking time needs to be reset when the door is
closed.
Power Saving Mode
When powered up for the first time, the oven will enter power saving mode.
When cooking finishes, the internal fan and light will last for 1 minute. Afterwards, the oven will enter
power saving mode.
Cleaning, Care & Maintenance
Switch off and disconnect from the power supply before cleaning.
Always keep the oven clean!
Clean the door frame, seal and neighbouring parts carefully with a damp
cloth when dirty.
Cleaning the door and oven front face
For best performance and to maintain the high degree of safety, the inner door panel and oven front
face should be free of food or grease build-up.
Wipe these parts with a mild detergent, rinse and wipe dry. Never use abrasive powders or pads.
Cleaning the control panel and plastic parts
Do not apply a detergent or an alkaline liquid spray to the control panel and plastic parts, as this may
cause damage to these parts.
Use a dry cloth (not a soaked cloth) to clean these parts.
Do not allow the control panel to become wet.
8
FB861_UK_A5_v1_20201102.indb 8
FB861_UK_A5_v1_20201102.indb 8
Telephone Helpline: 0845 146 2887
2020/11/2 13:27
2020/11/2 13:27

Advertisement

Table of Contents
loading

Table of Contents