Ram Expansion - Brother HL-3400CN Series User Manual

USER'S GUIDE

RAM Expansion

5-56
9. Retain the cover plate and two screws removed in Step 2 in case
you want to remove the MIO card later.
Fig. 5-72 Installing the MIO Card
This printer has 64 Mbytes of memory standard and 2 slots for optional
expansion memory. The memory can be expanded up to 320 Mbytes by
installing commercially available dual in-line memory modules
(DIMMs). (The standard memory fitted can vary depending on the printer
model and country.)
This printer uses memory module which is:
100 pins, no-parity, SDRAM with 64Mbit or more.
This printer is not compatible with Extended Data Output (EDO) DIMM,
or DIMM which uses 16Mbit SDRAM.
The following capacity of DIMM can be installed:
• 16 Mbyte TECHWORKS
• 32 Mbyte TECHWORKS
• 64 Mbyte TECHWORKS
• 128 Mbyte TECHWORKS
In general, the DIMM must have the following specifications:
Type: 100 pin and 32 bit output
CAS Latency: 2 or 3
Clock Frequency: 66Mhz or more
Capacity: 16,32, 64 or 128 Mbyte
Height: 46mm (1.8 inches) or less
Parity: NONE
Dram Type: 64 M bit SDRAM 4 Bank
SDRAM can be used.
Notes
There might be some DIMMs which will not work with this printer.
For more informationabout the memory cards consult the dealer
where you purchased the printer.
For the latest information: http://www.brother.com
PM-HP 16M-BR
PM-HP 32M-BR
PM-HP 64M-BR
PM-HP 128M-BR