Eaton Sure-Lites SELIN Series Installation Instruction

Installation Instructions for the Sure-Lites SELIN Series Emergency Light
¡ ¢ £ ¤ ¥ ¦ £ § ¢ ¨ ¢ ©   ¦ ©  ¨ ¢  ¤ ¦   ¢ £
¥ ¡ ¤ ¨ !  ¨ "   ¥  ¢  ¨ ¨ " ¢ ! ¦ £ © ¨ ¤ !
2. Do not let power supply cords touch hot surfaces.
3.Do not mount near gas or electric heaters.
4.Equipment should be mounted in locations and at heights
where it will not readily be subjected to tampering by
unauthorized personnel.
5. The use of accessory equipment not recommended by Sure-
Lites may cause an unsafe condition.
6.Do not use this equipment for other than its intended purpose.
7.Some equipment covered by these instructions are approved
for remote fixtures. This equipment hve a load fuse. Check
load rating of equipment to calculate remote capability . DO
NOT exceed remote capacity rating. the fuse will be cutting
off when over loaded.
MAX MOUNTING HEIGHT: SELIN25R10SD - 14ft
SELIN50R7SD - 21ft
SELIN60R4SD - 24ft
    ¥ ¦ © ¥   ¢     ¢ ©  ¤  ¦ £ ¥
¦ £ §  ¡ ¢  ¨ ¨ " ¨ £ § #
$ % & ' ( ) 0 1 2 3 4 5 % 3 6 7 ( 3 '
8 9 @ A B C C D A E F B G D H I E P Q @ D B
9 C @ E I T T 9 C U B H @ D H V 9 A 9 C U W
$ % & ' ( ) X % 5 2 Y 0 1 2 3 4 5 % 3 6 7 (
` P C B E a Q I T 9 P 9 D b c A B C @ Q T E I C D T D
INSTALLATION
d e f g h i
Loosen the four screws at corners of cover and
open cover.
d e f g p i
Drilling position as shown in the Fig. A shaded
area.
d e f g x i
Mount the unit securely in place through the four
holes provided in the housing,please follow the
Hoffman instructions sheet.
y €  ‚ ƒ „
Make conduit connections using UL listed suitable
for wet location connector. See "INSTALLATION OF
CONDUIT, CONDUIT CONNECTOR (HUB) AND
GROUNDING ADAPTER."
INS #
% 4 v w w
t u
X % q r s
H A 9 H A Q 9 E R H D I S D H R D P B H D
3 '
A E H 9 A 9 I C W