Pioneer 9601 Instruction Manual

INSTALLATION
* Please read the following notice before installation *
1. Make sure that you or the professional are using our original connector in your first
installation, otherwise it could cause a short circus in the radio because the order of the
cable does not match correctly. If you use another connector, the radio may not turn on
or make any sound, even when you use our original connector for the second attempt.
Any damage caused by misuse of the wiring will not be included in the term of the
warranty.
2. After installing the radio, you may see some regular problems that most buyers can see,
but most of which can be verified and resolved by "F&Q"
Remove the stereo carefully from the box. keeping the box. For warranty and service of
the unit.
1. Remove the screws.
2. Unpack the car's dashboard and mounting bracket.
3. Check the size of the board window to meet the requirements. The holes of the lefit
alignment screws and the right plates.
4. By machine support fixed with screws in the dashboard.
5. Control panel installed.
PRECAUTIONS
Choose the mounting location carefully so that the unit will not interfere with the normal
driving functions of the driver.
Avoid installing the unit where it would be subject to high temperatures, from direct
sunlight or hot air from the heater, or where it would be subject to dust, dirt or excessive
vibration.
Use only the supplied mounting hardware for a safe and secure installation.
Adjust the mounting angle as desired.
Note
: Keep the release Key in the safe place as you may need it in future to remove the
unit from the car.