Install Menu - Bosch FlexiDomeXF VDC-485V03-20 Installation Instructions Manual

FlexiDome
XF & DN
Installer Settings

Install menu

Function Selection
SET
FOCUS
NOW
COMM ON, OFF
SYNC Select submenu
CAMERA ID Select submenu
HEATER AUTO, OFF
DEFAULTS Select submenu
EXIT
Adjustment procedure DC-iris Lens:
1. Unlock the focus locking screw.
2. SET BACK FOCUS NOW is highlighted in the menu.
3. Turn the focus adjustment as required.
4. Lock the focus locking screw.
5. Exit the menu selection.
Install sync submenu
Function Selection
SYNC INTERNAL, LINE
LOCK
DETECTED
SYNC
VPHASE 0, 2, ... 358
EXIT
Note
VPHASE cannot be accessed if there is no valid locking signal.
Bosch Security Systems | 2005-10 | V1.0
| Installation Manual
Description
Forces the lens to fully open the iris. Adjust the
lens focus now.
Bilinx communication ON/OFF
Select to access the synchronization functions
Select to access ID menu
Select AUTO to enable the thermostatically
controlled heater function
Return all settings for all modes to factory defaults
Exit the menu
Description
Select INTERNAL for free running camera
operation, select LINE LOCK to lock to the power
supply frequency.
Shows the actual sync mode used by the camera.
Adjusts the vertical phase offset (when in LINE
LOCK mode and a valid power supply frequency
is detected).
Return to the Install menu
EN | 26