Table of Contents
Advertisement
Performance Characteristics
Table 1-6: Certifications and compliances (cont.)
Category
Australian/New Zealand
declaration of Conformity EMC
EC Declaration of Conformity -
Low Voltage
Approvals
Installation Category Description
Pollution Degree
Conditions of Approval
IEC Characteristics
1-16
Standards or description
Complies with EMC provision of Radio-communications Act per the following standard:
AS/NZS 2064.1/2
Compliance was demonstrated to the following specification as listed in the Official Journal of the
European Communities:
Low Voltage Directive 73/23/EEC, amended by 93/68/EEC
EN 61010 1/A1:1992
Complies with the following safety standards:
UL3111-1, First Edition
CAN/CSA C22.2 No.1010.1 92 Safety requirements for electrical equipment for
Terminals on this product may have different installation (over-voltage) category designations. The
installation categories are:
Category
Examples of products in this category
CAT III
Distribution level mains (usually permanently connected). Equipment at this
level is typically in a fixed industrial location.
CAT II
Local level mains (wall sockets). Equipment at this level includes appliances,
portable tools, and similar products. Equipment is usually cord connected.
CAT I
Secondary (signal level) or battery operated circuits of electronic equipment.
A measure of the contaminates that could occur in the environment around and within a product.
Typically the internal environment inside a product is considered to be the same as the external.
Products should be used only in the environment for which they are rated.
Pollution Degree 2
Safety Certifications/Compliances are made for the following conditions:
Altitude (maximum operation): 2000 meters
Equipment type:
Test and Measuring
Installation Category II (as defined in IEC 61010-1, Annex J)
Pollution Degree 2 (as defined in IEC 61010-1)
Safety Class I (as defined in IEC 61010-1, Annex H)
Industrial, Scientific, and Medical Equipment: 1992
Safety requirements for electrical equipment for
measurement, control and laboratory use.
Standard for electrical measuring and test equipment.
measurement, control and laboratory use.
Normally only dry, nonconductive pollution occurs. Occasionally a
temporary conductivity that is caused by condensation must be
expected. This location is a typical office/home environment.
Temporary condensation occurs only when the product is out of
service.
AWG2021 Service Manual
Advertisement
Chapters
Table of Contents
