Indicator Lamp In The Charging Station - Husqvarna Automower 405X Operator's Manual

Message Cause
Difficult finding home
The product has been following the boundary
wire several laps without finding the charging
station.
Needs manual charg-
The product is set to the
ing erating mode.
Next start hh:mm The schedule setting prevents the product
from operating.
The rest period is in progress. The product
has an inbuilt standby period according to
the Standby time table.
The clock or date in the product is not cor-
rect.
Today's mowing
The product has an inbuilt standby period ac-
completed cording to the Standby time table.
Connectivity problem
Potential problem on the connectivity circuit
board in the product.

6.4 Indicator lamp in the charging station

The indicator lamp in the charging station must show a solid or flashing green light for a correct installation. If not,
follow the instructions in the troubleshooting guide below.
Speak to your Husqvarna customer service for more information.
Light Cause
Green solid light Good signals
Green flashing light The signals are good and
bled.
Blue flashing light The boundary wire is not connected to the
charging station.
Damage in the boundary wire.
Red flashing light Interference in the antenna of the charging
station.
Red solid light Error in the circuit board or incorrect power
supply in the charging station. The error must
be corrected by an authorized service techni-
cian.
1650 - 003 - 24.02.2021
Action
The installation has not been done correctly.
Refer to
20 .
Wrong corridor width setting on boundary
wire. Refer to
page 20 .
The product was started on a Secondary
area with the Main area setting.
Secondary area op-
Put the product in the charging station.
Change the schedule settings. Refer to
Schedule on page 22 .
This behavior is normal and no action is re-
quired.
Set the time. Refer to
on page 29 .
This behavior is normal and no action is re-
quired. Refer to
on page 22 .
Restart the product. If the problem stays
speak to your authorized service technician.
Action
Usual operation of the product.
ECO mode is ena-
Usual operation of the product. Refer to
mode on page 28 .
Make sure that the boundary wire is correctly
installed in the charging station. Refer to
install the boundary wire on page 20 .
Find out where the damage is. Replace the
damaged section with new boundary wire.
Speak to your Husqvarna customer service.
Speak to your Husqvarna customer service.
To install the boundary wire on page
To install the boundary wire on
To set the time & date
To get access to the menu
Troubleshooting - 41
ECO
To