Page 2
Please check the package contents, please see Figure 1. Screw the antenna as shown in figure 2. Figure 1 Connect your PC to a LAN port of the LP-1521 as shown in figure 3. Connect your ISP cable to the WAN port as shown in Figure 2 figure 4 (ISP: Internet Service Provider).
Page 3
Properties. Figure 6 In the window shown in figure 6, select: Use the following IP address and input an IP address in the LP-1521 default IP address range. In this example we have selected the following address: 192.168.1.201, and the LP-1521´s default address is: 192.168.1.254. Input in: Subnet mask: 255.255.255.0, in: Default...
Page 4
LAN Interface , in: DHCP select: Disabled and then select: Apply changes (remember to verify that the IP address of the LP-1521 is not being used in the network you are going to connect to. (It is recommended to use an IP address inside the destination segment for proper management).
Page 5
Wireless - Equipment - 2.4 GHz - LP1521 123 Manual Universal Repeater Mode Installation, with PoE In figure 12, select: OK and then reboot. Once this configuration has been made, the LP-1521 will connect automatically even though you disconnect or connect it again. Figure 12 Important recommendation.