Main Switch - Husqvarna K 535i Workshop Manual

3. Remove the power trigger lockout and the power
trigger from their brackets in the handle.
4. Remove the main switch piston and the recoil
spring.
5. Make sure that there is tension in the recoil spring.
6.5.2 To assemble the power trigger
1. Put the recoil spring and main switch piston onto the
throttle.
2. Assemble the throttle and the power trigger and
power trigger lockout to their brackets in the handle.
3. Make sure the holders are in the handle.
4. Put the recoil spring in the throttle lockout.
744 - 002 -

6.6 Main switch

6.6.1 To disassemble the main switch
CAUTION: Do not pull the cables.
1. Disassemble the wet system. Refer to
the wet system on page 9 .
2. Disassemble the handle half. Refer to
disassemble the handle half on page 10 .
3. Remove the main switch from the other handle half.
4. Release the catch with a small screwdriver and
remove the connector.
To remove
To
Repair instructions - 11