AEG SR 4328 CD/MP3 Instruction Manual page 37

3. Through the loudspeakers you can hear the playback
of the sound from the external device; with the VOL-
UME control (15) you can change the volume. The CD
buttons do not have any function.
4. For the remaining procedure please see the operating
instructions of the external sound source.

NOTE:
Adjust the volume of the external device to a comfor-
table level.
Listening to the Radio
1. Turn the function selector switch (16) to the RADIO
position.
2. Use the band selector switch (4) to select the desired
frequency band.
VHF (Stereo) = FM ST., VHF = FM,
Medium wave = AM (Mono)
3. Tune in the desired station with the station adjust-
ment knob TUNING (6).
4. The FM ST control lamp (21) only lights up when you
have selected FM stereo and the station is being re-
ceived in stereo quality. If reception is too weak and
there is noise on the station being received, this lamp
will flicker. Where reception is bad we recommend
switching to FM.
5. For VHF/FM mode pull out the telescopic antenna (1)
and turn it to improve reception.
6. An aerial is integrated into the device for the recep-
tion of AM stations. The machine can be aligned
to the station by turning it. In this frequency band
programs are transmitted in „mono" only.
Playing CDs/MP3
This is how you play a CD
1. Turn the function selector switch (16) to the „CD/
MP3" position.
2. Open the CD compartment (3) by pulling the lid
upwards by the tab (7).
3. Insert an audio CD with the printed side facing
upwards on to the central cone so that the CD clicks
into place and then close the lid of the CD compart-
ment.
4. After a few seconds the total number of songs/tracks
is shown in the display.

NOTE:
In the case of CDs in MP3 format the number of
folders is briefly displayed at first.
05-SR 4328 AEG.indd 37
5. The CD will play from the first title. The current track
and the playing time that has elapsed are shown in
the display.

NOTE:
With CDs in MP3 format the current track and
folder are shown alternately in the display.
6. In order to remove a CD, please press the STOP key
(10), open the CD compartment and lift the CD out
carefully.
Always keep the CD deck closed.

NOTE:
• In the case of CDs in MP3 format that contain fol-
ders, when the device changes to a different folder
001 appears for the first track of the new folder.
• If a disc is incorrectly inserted - or no disc has been
inserted - the symbol „CD READ" and the word „NO
DISC" appear in the display.
• Playback of CDs produced by the user cannot be
guaranteed due to the large variety of software and
CD media available.
Description of the CD buttons
PLAY/PAUSE (11)
You can briefly interrupt and resume playback using this
button. The playing time that has elapsed flashes in the
display. Pressing again continues playback.
SKIP+/SKIP- (8/9)
With an audio CD or a CD in MP3 format playing:
With SKIP + you can jump to the next or previous track
etc.
• If the button is kept pressed down, the machine
starts to search through the tracks.
The SKIP - button can be used as follows:
Press once = This starts the current track again
from the beginning.
Press twice = This jumps back to the previous
track.
Press three times = This plays the song before etc. If the
button is kept pressed down, the
machine starts to search through the
tracks.

NOTE:
In the case of CDs in MP3 format that contain folders,
when the device changes to a different folder 001
appears for the first track of the new folder.
STOP (10)
The CD stops.
English
37
20.10.2009 17:16:26 Uhr