Kenwood HM220 Series Instructions

a
b
c
d
e
safety
Read these instructions carefully and retain
l
for future reference.
Remove all packaging and any labels.
l
If the plug or cord is damaged it must, for
l
safety reasons, be replaced by Kenwood or
an authorised Kenwood repairer in order to
avoid a hazard.
DO NOT process hot ingredients.
l
Do not operate your appliance
l
for longer than 6 minutes without
a rest period. Unplug and allow
to cool for 15 minutes between
operations. Processing continuously
for longer periods can damage your
appliance.
Never put the handmixer body in water or
l
let the cord or plug get wet.
Keep fingers, hair, clothing and utensils
l
away from moving parts.
Never let the cord touch hot surfaces or
l
hang down where a child could grab it.
Ensure the cord is fully unwound before
l
using the handmixer.
Always switch off the appliance and
l
disconnect from the power supply, if it
is left unattended, before assembling,
disassembling or cleaning.
Never use a damaged handmixer. Get
l
it checked or repaired: see 'service and
customer care'.
Never use an unauthorised attachment.
l
Children should be supervised to ensure
l
that they do not play with the appliance.
This appliance shall not be used by children.
l
Keep the appliance and its cord out of
reach of children.
Misuse of your appliance can result in injury.
l
Appliances can be used by persons with
l
reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given
supervision or instruction concerning use
of the appliance in a safe way and if they
understand the hazards involved.
Only use the appliance for its intended
l
domestic use. Kenwood will not accept
any liability if the appliance is subject to
improper use, or failure to comply with
these instructions.
Cleaning
Always switch off, unplug and remove the
l
beaters before cleaning.
Never put the handmixer body in water or
l
let the cord or plug get wet.
beaters
Wash by hand or in your dishwasher, then
l
dry.
handmixer body
Wipe with a damp cloth, then dry.
l
Before plugging in
Make sure your electricity supply is the same as the one shown on the
l
rear of your handmixer.
No action is required to switch between 50Hz and 60Hz.
l
Important – Plug and Fuse Information
The wires in the cord are coloured as follows:
l
Blue = Neutral
Brown = Live.
If the plug supplied with your appliance has a fuse fitted it is rated 3A. If
l
the fuse fails it must be replaced with one of the same rating.
Note:
For non-rewireable plugs the fuse cover MUST be refitted when replacing
l
the fuse. If the fuse cover is lost then the plug must not be used until
a replacement can be obtained. The correct fuse cover is identified
by colour and a replacement may be obtained from your Kenwood
Authorised Repairer (see Service).
If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY.
l
An electric shock hazard may arise if an unwanted non-rewireable plug is
inadvertently inserted into a 13A socket outlet.
This appliance conforms to EC Regulation 1935/2004 on materials and
l
articles intended to come into contact with food.
know your Kenwood
before using your handmixer
for the first time
handmixer
1 Wash the beaters: see 'cleaning'.
a speed switch
b beater release button
c beaters
d grip clip
e cable tidy
see illustrations