Quincy lab 140E-1 Series Operating Manual

Control Self Diagnostics
Control prompts will only display when a fault or alarm condition exists.
ALARM Codes "S.ERR" & "- - - -" ALARM Code "E333"
or
Indicates Internal Circuit Error
Indicates Input Error
Check to make sure Thermocouple Turn Controller OFF and On. If problem
wiring is connected securely remains, replace Controller
Common Replacement Components
All replacement components are readily available and are easily replaced in the field.
COMPONENT MODEL VOLTAGE PART #
Digital Controller All All 401-1230
Relay All All 401-1235
Push Button Switch All 115V 401-2213
Push Button Switch All 401-2213-1
230V
Thermocouple All All 401-1231
Magnetic Catch (set) All All 401-1214
10-140E
Wire Shelf All 101-1000
10-180E
12-140E
Wire Shelf All 101-3000
12-180E
10-140E
Shelf Supports (2) All 101-1001
10-180E
12-140E
Shelf Supports (2) All 101-3001
12-180E
Maintenance / Control Calibration
To clean interior and exterior surfaces, use a damp cloth with or without an all-purpose cleaner. Avoid
commercially available oven cleaners. The acrylic door should only be cleaned using a lint-free cloth, with or
without water. Paper towels can mar the surface of the acrylic door. Use of any commercial cleansers on the
acrylic door will cause crazing and cracking of the surface of the acrylic over time. Periodically, check the
accuracy of the control's temperature display against a known accurate or calibrated device. This should be
done with an empty chamber after the set temperature becomes steady (typically after 45 - 60 minutes).
Calibrate the control in the control's function menu, level 3 (see page 3).
Technical Support
If you have any questions or need technical assistance, please contact Quincy Lab
Email: information@quincylab.com
Voice: 800-482-HEAT (4328)
Fax: 773-622-2282
Limited Warranty
Quincy Lab, Inc. warrants to the original purchaser that this product will be free from defects in material and
workmanship under normal use throughout the warranty period. The standard warranty period for this
instrument is eighteen months from date of shipment. The instrument warranty is
supplemented with a three year warranty on
invoice or shipping documents to determine the active warranty period. This warranty covers
parts & labor (labor at factory only) and shipping cost for replacement parts.
ALARM Code "E111"
Indicates Internal Memory Error
Turn Controller OFF and On. If problem
remains, replace Controller
COMPONENT MODEL VOLTAGE PART #
Acrylic Door/Hinge 10-140E All 401-1010
12-140E All 401-1211
Acrylic Door/Hinge
115V 401-2025
Motor w/ Fan & Brkt
All
Motor w/ Fan & Brkt All 230V 401-2025-1
10-140E
Fuse (3 amp) All Q-1196
12-140E
10-180E
Fuse (5 amp) All Q-1193
12-180E
Fuse Holder (Black) All All Q-1197
Fuse Holder (Red) All All Q-1198
6' Cord & Plug All 115V 101-1803
6' Cord & Plug All 230V 101-1603-1
Tech Support at:
Quincy Lab, Inc.
1925 N Leamington Ave
Chicago, Illinois 60639
the heating element. Please refer to your
Quincy Lab, Inc.
Model 12-140E-1
SPECIFICATIONS
Interior Dimensions
INCHES W x H x D
(CM) W x H x D
Exterior Dimensions
INCHES W x H x D
(CM) W x H x D
Weight (lbs)
Cubic Foot Capacity
Standard Electrical
VOLTS / WATTS
Temperature Range
Common Unit Specifications
Operating Environment: Indoor use, altitude to 6,500 ft. (2,000m) Installation Category II,
Storage Temperature:
Approvals:
Compliance:
Common Unit Construction
Exterior: Powder-Coated Steel
Insulation: Fiberglass
Thermo-control: PID Microprocessor
Issue Rev D 0419
Copyright Quincy Lab Inc. 2010
Quincy Lab, Inc.
PAGE 4
Model Series 140E-1 & 180E-1 (230 Volts)
General Purpose Incubators
OPERATING MANUAL
Model 10-180E-1
MODEL MODEL MODEL
10-140E-1 12-140E-1 10-180E-1
12x10x10 18x16x12 12x10x10
31x25x25 46x41x30 31x25x25
13x15x11 19x21x13 13x15x11
33x38x28 48x53x33 33x38x28
19 lbs 33 lbs 19 lbs
230 / 120 230 / 235 230 / 270
Pollution Degree 2, ambient temperature 10 o C/50
80% RH maximum.
-10 o C/14 o F to 70 o C/158 o F, 70% RH maximum.
Underwriter's Laboratory Listed, Laboratory Equipment, C/UL
United States/Canadian. E212550 (115VAC models only)
UL Standard 61010-1, IEC 61010-1, 2nd Edition.
Interior: Aluminum
Door: 140E-1: Acrylic, 180E-1: Steel Insulated
Heater: Resistive-Tubular Incoloy
1925 N. Leamington Ave. Chicago, Illinois 60639 1-800-482-HEAT (4328)
MODEL
12-180E-1
18x16x12
46x41x30
19x21x11
48x53x33
33 lbs
230 / 385
o F to 35 o C/95 o F,
PAGE 1