Zennio Lumento DX4 Technical Documentation

4-channel constant voltage PWM dimmer in DIN rail for DC LED loads with 6 binary/analogue inputs
ZDI-RGBDX4
FEATURES
•
4 constant voltage channels configurables (independent channels,
RGBW channels and RGB+W channels).
•
6 analog/digital inputs.
•
Master Light control.
•
External 12-30VDC power supply.
•
Manual output operation with push button and LED status indicator.
•
Total data saving on KNX bus failure.
•
Integrated KNX BCU.
•
Dimensions 60 x 90 x 79mm (4,5 DIN units).
•
DIN rail mounting (EN 50022), through pressure.
•
Conformity with the CE directives (CE-mark on the right side).
1. External power supply 2. Colour shift status LED* 3. Colour shift control buttons*
6. Output channels
Programming/Test button: short press to set programming mode. If this button is held while plugging the device into the KNX bus, it enters the safe
mode. If this button is held for more than 3 seconds, the device enters the test mode.
Programming/Test LED: programming mode indicator (red). When the device enters the safe mode, it blinks (red) every half second. The manual mode
is indicated by the green color. During the start-up (reset or after KNX bus failure) and if the device is not in safe mode, it emits a red flash. A blue blink
represents an error.
GENERAL SPECIFICATIONS
CONCEPT
Type of device
Voltage (typical)
Voltage range
KNX supply
Maximum
consumption
Connection type
External power supply
Operation temperature
Storage temperature
Operation humidity
Storage humidity
Complementary characteristics
Protection class
Operation type
Device action type
Electrical stress period
Degree of protection
Installation
Minimum clearances
Response on KNX bus failure
Response on KNX bus restart
Operation indicator
Weight
PCB CTI index
Housing material
¹ Maximum consumption in the worst-case scenario (KNX Fan-In model)
© Zennio Avance y Tecnología S.L.
7. KNX connector 8. Programming/Test LED
Voltage
29VDC (typical)
24VDC¹
Edition 6
2
3
4
5
6
4. Channel control button
9. Programming/Test button
DESCRIPTION
Electric operation control device
29VDC SELV
21..31VDC
mA
6.5
10
Typical TP1 bus connector for 0.80mm Ø rigid cable
12-30VDC
0°C .. +55°C
-20°C .. +55°C
5 .. 95%
5 .. 95%
Class B
III
Continuous operation
Type 1
Long
IP20, clean environment
Independent device to be mounted inside electrical panels with DIN rail (EN
50022)
Not required
Data saving according to parameterization
Data recovery according to parameterization
The programming LED indicates programming mode (red), test mode
(green) and error (blue blinking). Colour shift LEDs show the current colour.
Each output LED indicates its status.
184g
175V
PC FR V0 halogen free
Further information
Lumento DX4
TECHNICAL DOCUMENTATION
1
9
8
Figure 1: Lumento DX4
5. Channel status LED
mW
188.5
240
www.zennio.com
10
6
7
10. Inputs
Page 1/2