Canon Creative park Zebra Assembly Instructions

Boomerang : Assembly Instructions
Assembling the Zebra, Command Four, and Star boomerangs
* Note that liquid glue may cause warping. We recommend using a stick glue.
* After gluing the parts together, place the boomerang on a flat surface with a book or similar object placed
on top. Store the boomerang under the same conditions. Always retune the boomerang before throwing it.
Make an indentation on the tip of the top
surface and align with the middle surface.
Glue these surfaces together.
Top surface
Assembly Instructions : Three A4 sheets (No. 1 to No. 3)
After gluing the top and middle surfaces
together, glue the bottom surface to the
glued assembly. Then flip the boomerang
upside and glue the tip.
Middle surface
name
After gluing the components together, to flatten the
boomerang, place it under some books and allow to
stand for some time. Before using it, tune the boomerang
as described on page 3 of the Assembly Instructions.
Glue the bottom surface
into position.
Bottom surface
1
Fold back the tip located on the top
surface and glue into position.