Page 1
Installation Instructions Advantium ® 120V Built-In SpeedCook Oven ZSC1001 PSB9100 31-2000002-3 MFL59060919 07-20 GEA GE is a trademark of the General Electric Company. Manufactured under trademark license.
Safety Information CONTENTS BEFORE YOU BEGIN Design Information Read these instructions completely and Models Available ..........2 carefully. Product Dimensions and Clearances ....3 IMPORTANT — Save these instructions Tools Required ..........3 for local inspector’s use. Parts Supplied ........... 3 IMPORTANT —...
Installation Preparation ELECTRICAL REQUIREMENTS Single Advantium 120 Installation: This product requires a 120-volt, 60 Hz, 15-amp circuit and draws 1.8 kilowatts. This product must be connected to a supply circuit of the proper voltage and frequency. • Wire size must conform to the requirements of the National Electrical Code or the prevailing local code for this kilowatt rating.
Page 5
Standard Installation Preparation IMPORTANT: Always maintain 36-3/4” minimum PREPARE THE OPENING height from the floor to the cutout in any single or (CONT.) combined installation. Installation over a Warming Drawer: Construct 23-1/2” solid bottom 27” or 30” PREPARE THE OPENING - Min.
Page 6
Standard Installation Preparation IMPORTANT: Always maintain 36-3/4” minimum height from the floor to the cutout in any single or combined installation. PREPARE THE OPENING (CONT.) 27” or 30” Construct Installation over a Wall Oven and Warming solid bottom 23-1/2” Drawer: - Min.
Page 7
Flush Mount Installation Preparation (Monogram Only) IMPORTANT: Always maintain 36-3/4” minimum height from the floor to the cutout in any single or combined installation. PREPARE THE OPENING PREPARE THE INTERIOR Cut and install side cleats: The Advantium 120 can be installed in combination with other Built-In Appliances.
Page 8
Flush Mount Installation Preparation (Monogram Only) IMPORTANT: Always maintain 36-3/4” minimum height from the floor to the cutout in any single or combined installation. PREPARE THE OPENING 23-1/2” min. The Advantium 120 can be installed beside another Advantium 120 in a side-by-side combination. Double Advantium 120 Installation: Cut the opening in a cabinet to the dimensions shown.
Installation STEP 1 SLIDE OVEN INTO CUTOUT STEP 3 INSTALL SIDE TRIM FOR 30” CABINET INSTALLATION ONLY. Two people are required to CAUTION SKIP THIS STEP IF YOU HAVE 27” WIDE lift the oven into the opening. CABINETRY. Grasp the bottom at the front and rear. DO NOT USE THE HANDLE TO LIFT THE OVEN.
Page 10
NOTE: While performing installations described in this book, safety glasses or goggles should be worn. NOTE: Product improvement is a continuing endeavor at GE Appliances. Therefore, materials, appearance and specifications are subject to change without notice. Printed in China...
Page 11
Instrucciones de Instalación Horno con Velocidad de Cocción Incorporada Advantium® 120V ZSC1001 PSB9100 31-2000002-3 MFL59060919 07-20 GEA GE es una marca de la Empresa General Electric. Fabricado bajo licencia de la marca registrada.
Page 12
Información sobre Seguridad ANTES DE COMENZAR CONTENIDOS Información de Diseños Lea estas instrucciones en su totalidad y Modelos Disponibles ..........2 atentamente. Dimensiones y Espacios de Despeje del Producto .. 3 IMPORTANTE — Conserve estas Herramientas Necesarias .......... 3 instrucciones para uso del inspector local. Piezas Suministradas ..........
Preparación de la Instalación REQUISITOS ELÉCTRICOS Instalación Simple del Advantium 120: Este producto requiere un circuito de 120 voltios, 60 Hz, 15 amperes y consume 1.8 kilowatts. Este producto se debe conectar a un circuito con un suministro correcto de voltaje y frecuencia. •...
Standard Installation Preparation IMPORTANTE: Siempre deje una altura mínima de 36 3/4” desde el piso hasta el recorte en cualquier instalación, ya sea simple o combinada. PREPARACIÓN DE LA ABERTURA PREPARACIÓN DE LA ABERTURA Instalación sobre un cajón calentador (CONT.) El Advantium 120 se podrá...
Page 16
Preparación para la Instalación Estándar IMPORTANTE: Siempre deje una altura mínima de 36 3/4” desde el piso hasta el recorte en cualquier instalación, ya sea simple o combinada. PREPARACIÓN DE LA ABERTURA Construya un 27” o 30” fondo sólido, (CONT.) 23-1/2”...
Page 17
Preparación de la Instalación para el Montaje al Ras (Monogram Únicamente) IMPORTANTE: Siempre deje una altura mínima de 36 3/4” desde el piso hasta el recorte en cualquier instalación, ya sea simple o combinada. PREPARE EL INTERIOR PREPARACIÓN DE LA ABERTURA Corte e instale los ristreles laterales: El Advantium 120 se podrá...
Page 18
Preparación de la Instalación para el Montaje al Ras (Monogram Únicamente) IMPORTANTE: Siempre deje una altura mínima de 36 3/4” desde el piso hasta el recorte en cualquier instalación, ya sea simple o combinada. Mín. de 23-1/2” PREPARACIÓN DE LA ABERTURA El Advantium 120 puede ser instalado junto a otro Advantium 120 combinando uno al lado del otro.
Instrucciones de Instalación PASO 1 DESLICE EL HORNO POR PASO 3 INSTALACIÓN DE LA LA ABERTURA MOLDURA LATERAL PARA LA INSTALACIÓN DEL GABINETE Se requiere contar con dos PRECAUCIÓN E 30” ÚNICAMENTE. SALTEE ESTE PASO personas para colocar el horno en la abertura.
Page 20
NOTA: Al realizar las instalaciones descriptas en este libro, se deberán usar anteojos o gafas de seguridad. NOTA: GE Appliances se esfuerza de forma constante para mejorar sus productos. Por lo tanto, los materiales, el aspecto y las especificaciones están sujetos a cambios sin aviso previo.