Exiting Service Mode; Verifying Service Data Changes; Resetting Wega (User) Menu To Factory Defaults - Sony KF-E42A10 Service Manual

SERVICE MENUS
(CATEGORIES ONLY)
79
79 0,&52 *6$,3+
67$786 659B7(67
&21),*
781(5&&
)$1
9,'(26:
$8',2
)$,/85(
(5525 '(9
6<67(0
'(%8*
KF-E42A10/E50A10
%(
%( 0,&52
&21),*85$7,21
/3)7
&&3B&967
&&3B<897
&&3B&)7
&&3B6,7
&&3B$'7
,37
&67
68%B&67
&77
6)7
6)37
6115
6166
,1'(;B,';
&$3
&$3
*53+
2$$B296&
2$$B$''$
2$$B:0B865
23)
23)3&
23)09
23)+6
23)
3$1/
9$5,$7,21
%/B,';
'%/B&75/
',00(5B&75/
$'&2
$'&B$'7
$'&
$'&
$'&
3&B&21),*
$'$B&75/
$'$B065B7$%/(B190
'  B
'  &85
'  B7*B63
'  B,5,6B8)
'%/B&75/B$&
237,21B(
$5
$*
$%
'  3,&
'  731
*%B5*%
*:B63(&,$/

2-4-1. EXITING SERVICE MODE

After completing the changes, exit service mode by turning off the set
using the Remote Commander or the power switch.
NOTE: After exiting service mode wait 2 minutes before restarting
the set to allow the fans to shut down properly.

2-5. VERIFYING SERVICE DATA CHANGES

1. After completing all adjustments turn the set off with the Remote
Commander and WAIT for the fans to turn off before proceeding to
the next step.
Note: It may take up to two minutes for the fans to stop.
Caution: To avoid over heating the lamp, do not unplug the set
until the fans have stopped.
2. After the fans have stopped, unplug the set from the AC outlet, then
plug the set back in the AC outlet.
3. To verify the changes repeat steps 1 through 3 of 2-4. Using the
Remote Commander to Change Service Data.
4. To exit service mode, turn the power off by pressing POWER .
Wait 2 minutes before restarting the set to allow the fans to
completely shut down or the Service Menu will appear on the screen.
NOTE: After exiting service mode wait 2 minutes before restarting
the set to allow the fans to shut down properly.
2-6. RESETTING WEGA (USER) MENU TO
FACTORY DEFAULTS
Use the following instructions to restore the User Controls and
Channel Memory settings to the preset factory conditions.
1. Turn the TV on by press POWER on the Remote Commander.
2. While holding down the on the Remote Commander, press the
POWER button on the Front Panel of the set.
The set restarts and displays the initial setup screen. This may take
several minutes.
KF-E42A10/E50A10
73