Table of Contents
Advertisement
Preparation before using
■ Battery installation
Before product leaving factory,
battery has been installed in printer.
1. Open protection film of battery contacts.
2. Install battery refer to above diagrams.
3. Fasten battery.
■ Printing paper roll installation
1. Take down the sealing tape on printing paper roll;
2. Press cover-open button and open paper tank;
3. Put paper roll into paper tank;
4. Pull out a length of paper along with paper-out opening, then dose paper tank cover.
Remark:
1. Paper specification used by printer is: paper width 80mm (single side adjustable), paper roll
diameter 43mm.
2. Pay attention to direction of paper roll. If it's revered, it may cause empty printing or
non-process paper-feeding.
Advertisement
Table of Contents
