Download Print this page

Lakeside PWC-50 M4 Assembly & Use Instructions

Shore ramp

Download this manual

Shore Ramp PWC-50 (M4)

Assembly & Use Instructions

p/n: 000004

Lakeside Recreation LLC

www.lakesiderecreation.com

IMPORTANT NOTE ABOUT STAINLESS FASTENERS

Stainless fasteners may gall and seize up (cold weld) if assembled without lubrication. Be sure to apply a dab of the

supplied anti-seize compound to the threads of each stainless bolt prior to assembling the nut.

Assembly

1. Unpack the box and confirm that all the parts are present according to the parts list.

2. Lay the Keel Beam and Front Beam on a flat surface end to end, with the bottom access openings facing up. Assemble

them together using the 2 Connector Plates, and 16 sets of 1.00" 3/8-16 bolts, washers, and nuts. Get all the bolts

inserted and the nuts started before tightening any of them. Tighten all 16 sets of fasteners firmly.

Shore Ramp PWC-50

p/n: 000004 rev A

Page 1 2 Connector Plates, and 16 sets of 1.00” 3/8-16 bolts, washers, and nuts. Get all the bolts inserted and the nuts started before tightening any of them. Tighten all 16 sets of fasteners firmly. Shore Ramp PWC-50 p/n: 000004 rev A doc: 400005 copyright© 2018 Lakeside Recreation, LLC...
Page 3 CAUTION: Should the winch handle be released under load, keep clear of the rapidly spinning handle. Although not ideal, it is safest to then just allow the winch to unwind until the PWC comes to rest in the water. Shore Ramp PWC-50 p/n: 000004 rev A doc: 400005 copyright© 2018 Lakeside Recreation, LLC...
Page 4 One Year Limited Warranty LAKESIDE RECREATION products are warranted to be free from defects in materials or workmanship for one (1) year from the date of purchase. Within this period we will provide a replacement for any component that fails in normal use. Such replacement will be made at no charge to you, provided that you shall be responsible for any shipping charges and labor for replacement of the component.

000004