Inner Cover (Rear); Camera Cover (Upper) - Sony BRC-Z700 Service Manual

1-2-4. Inner Cover (Rear)

1. Remove the outer covers (right)/(left).
(Refer to Section 1-2-1.)
2. Remove the inner covers (center)/(right)/(left).
(Refer to Section 1-2-2.)
3. Remove the inner cover (front) assembly.
(Refer to Section 1-2-3.)
4. Remove the two screws, then remove the inner cover
(rear).
Tilt chassis assembly
Tape (A)
5. To install, reverse the removal procedure.
n
When attaching the inner cover (rear), be careful not to
catch the tape (A) inside the tilt chassis assembly.
BRC-Z700
Inner cover (rear)
PSW
2.6 x 6 (large)

1-2-5. Camera Cover (Upper)

n
When removing or attaching the camera cover (upper), be
careful not to touch the prism assembly in the rear of the
camera block assembly.
1. Remove the outer covers (right)/(left).
(Refer to Section 1-2-1.)
2. Remove the inner covers (center)/(right)/(left).
(Refer to Section 1-2-2.)
3. Remove the inner cover (front) assembly.
(Refer to Section 1-2-3.)
4. Remove the inner cover (rear).
(Refer to Section 1-2-4.)
5. Remove the two screws, then remove the camera cover
(upper) in the direction of the arrow.
PSW2.6 x 6
6. To install, reverse the removal procedure.
n
When attaching the camera cover (upper), align the
hook in the rear of the camera cover (upper) with the
hole in the rear of the camera cover (lower).
Camera cover (upper)
Hook
PSW2.6 x 6
Hole
Camera
cover (lower)
1-5