Advertisement
3-864-485-01 (1)
Battery Adaptor
Operating Instructions
Mode d'emploi
Bedienungsanleitung
Manual de instrucciones
Istruzioni per l'uso
DC-L10
Sony Corporation © 1998
Printed in Japan
A
1
3
2
B
1
1)
2)
2
3
1)
Cable clamp
2)
Power plug
5
1
4
C
D
Battery detach button
E
5
1
2
English
Features
• DC-L10 is a battery adaptor for the 6-inch/9-inch color video
monitor that uses the BP-L60/BP-L90 lithium battery pack.
6-inch: PVM 41 Series
9-inch: PVM/BVM 41/44 Series
• The upper adaptor is easy to detach. Simply loosen the bracket
screws. This is handy for removing the battery when it is being
transported.
• If the 6-inch/9-inch monitor is combined with a tuner (TU-
1041U/TU-1040E), you can install the battery adaptor on the
monitor by adding a power cord. Contact your Sony dealer or
local authorized Sony service facility for the additional power
cord.
Parts identification A
1 Bracket screws
2 Handle
3 Battery detach button
4 Fuse holder (5A)
5 DC power cord (4-pin XLR)
Installing the battery adaptor on the monitor B
1
1) Remove the monitor screws.
2) Install the brackets on both sides of the monitor. Lock with
the supplied screws (× 4).
2
Place the battery adaptor on the brackets. Lock the battery
adaptor with the bracket screws (× 4). You can tighten the
screws with fingers, a coin or screwdriver.
3
1) Place the cable clamp on the screw at the upper right rear
of the monitor.
2) Connect the power plug to the monitor's DC 12V input
connector. Secure the DC power cord with the cable clamp.
Folding the handle C
Push down on both sides of the handle and fold in either
direction. Make sure you fold the handle all the way down. If the
handle is not properly folded, the battery adaptor may not
function properly.
Installing the battery pack D
As shown in the figure, while the handle is folded down, place the
battery pack on the battery adaptor. Slide the battery pack in the
direction of the arrow. Push the battery pack in until it is locked.
To remove the battery pack, push the battery detach button.
Accessories supplied E
1 6-inch brackets (2)
2 9-inch brackets (2)
3 Screws M4 × 14 (8, including 4 extra)
4 Cable clamp (for DC power cord) (1)
5 Instruction manual (1)
Specifications
Dimensions 315 × 146 × 100mm (12
× 5
1
/
3
/
2
4
4
(w/h/d) (The bracket is not included; the handle is
upright.)
Mass
Battery adaptor: Approx. 1.4kg (3 lb 14 oz)
3
6-inch bracket (2): Approx. 800g (1 lb 12 oz)
9-inch bracket (2): Approx. 1,000g (2 lb 3 oz)
Design and specifications are subject to change without notice.
× 4 inches)
Advertisement
