Reboot The Airbridge From The Local Browser Ui - NETGEAR Insight Instant AirBridge User Manual

Reboot the AirBridge from the local
browser UI
You can use the local browser UI to reboot the AirBridge. This is very useful after you
installed the AirBridge at its permanent location, and the power adapter might not easily
reachable.
To reboot the AirBridge from the local browser UI:
1. Open a web browser from a computer that is connected to the same network as the
AirBridge or directly to the AirBridge through an Ethernet cable or WiFi connection.
2. Enter the IP address that is assigned to the AirBridge.
The login page displays.
If your browser does not display the login page but displays a security message and
does not let you proceed, see Log in to the AirBridge after initial setup on page 31.
3. Enter the AirBridge user name and local device password.
The user name is admin. The local device password is the one that you specified
the first time that you logged in. The user name and password are case-sensitive.
If you previously managed the AirBridge through the NETGEAR Insight app or Insight
Cloud portal, enter the Insight network password for the Insight network location to
which the AirBridge was assigned (see Connect over WiFi using the NETGEAR Insight
App on an iOS or Android mobile device on page 13).
The Device Status page displays the Device Information section and other sections.
4. At the top right of the page, select the Reset tab.
The page displays the Reboot the device section and the Restore the device to
default settings section.
5. Click the Reboot the device button.
The page displays the reboot progress.
WARNING: To avoid the risk of corrupting the firmware, do not interrupt the reboot.
For example, do not close the browser, click a link, or load a new page. Do not turn
off the AirBridge. Wait until the AirBridge finishes.
When the reboot is finished, the login page displays.
Maintain the AirBridge
Insight Instant AirBridge WBC502 User Manual
100 User Manual