From The Home Screen, "Apps Folder" → "Settings - Samsung Galaxy Feel2 Instruction Manual

Information
• You can use packet communication even when the Wi-Fi function is
ON. However, Wi-Fi connection takes precedence over the packet
communication while the terminal is connected to WI-Fi network.
When the terminal is disconnected from Wi-Fi network, connection
switches to 4G/3G/GSM network automatically. Be careful that
when you use the terminal while the connection is switched, packet
communication charge will be applied.
• Connect to a Wi-Fi network that requires user authentication, and
if the user authentication is unestablished when
communications may be carried out not by Wi-Fi, but rather via a
mobile network.
To perform Wi-Fi communications via these kinds of access
points, set the "Turn on Wi-Fi automatically" to OFF when making
connections with access points.
• To use docomo services via Wi-Fi, setting up of d ACCOUNT is
required. From the Home screen, "apps folder" → "Settings" →
"docomo service/cloud" → "d ACCOUNT setting"
■ Enabling Wi-Fi and connecting to network
1
From the Home screen, "apps folder" → "Settings" →
"Connections" → "Wi-Fi"
2
• Scanning available Wi-Fi networks starts automatically and a list is
displayed.
3
Tap a Wi-Fi network you want to connect → "CONNECT"
• To connect to a Wi-Fi network protected by security, enter a
password (security key) and tap "CONNECT".
• You can use WPS (Wi-Fi Protected Setup) to connect to Wi-Fi
network if it is compatible with WPS. On the Wi-Fi network list,
"Advanced" → "VIEW MORE" → "WPS push button"/"WPS PIN entry"
→ Operate on an access point.
• If "Auto reconnect" is marked, the network is automatically connected
when Wi-Fi is enabled.
Information
• The Wi-Fi network password (security key) is automatically saved
when connection is established so that you do not need to enter it
next time.
■ Deleting connection of Wi-Fi network
1
2
■ Setting Wi-Fi access point
• For information necessary for connection, refer to user manual of
is displayed,
• When the wireless LAN access point is set for connecting only to
1
2
3
4
■ Setting to turn on Wi-Fi automatically
Set to turn on Wi-Fi automatically in a place where you frequently use
Wi-Fi.
1
→
2
3
Information
• When Wi-Fi connection is disconnected with the access point
101
From the Home screen, "apps folder" → "Settings" →
"Connections" → "Wi-Fi"
Tap a connected Wi-Fi network → "FORGET"
wireless LAN access point you use. For connecting to company LAN
or using Public wireless LAN service, ask a network administrator or
service provider about the required information for connecting.
the MAC address registered device, register the MAC address of the
terminal to the wireless LAN access point. To check MAC address,
from the Home screen, "apps folder" → "Settings" → "Connections"
→ "Wi-Fi" → → "Advanced" → "VIEW MORE" and then see "MAC
address".
From the Home screen, "apps folder" → "Settings" →
"Connections" → "Wi-Fi"
"Add network"
Enter the network name → Set the security
• The possible certificate method is "WEP", "WPA/WPA2/FT PSK",
"802.1x EAP".
Enter a password → "CONNECT"
• If you set Security to "None", entering password is not needed.
From the Home screen, "apps folder" → "Settings" →
"Connections" → "Wi-Fi"
→ "Advanced"
"Turn on Wi-Fi automatically"
(such as memory card with embedded wireless LAN which does not
connect to Internet) while "Turn on Wi-Fi automatically" is ON, set
"Turn on Wi-Fi automatically" to OFF.
Settings