2. Install red and black cables from power cable kit
to vehicle bus bar as shown.
WINCH INSTALLATION
1. Align and install winch mounting bracket
U
chassis bracket
and front suspension bracket
V
using four screws
specification.
TORQUE
20ft. lbs. (27.1 Nm)
w
2. Connect blue
and yellow
corresponding color terminals on winch assembly
t
as shown. Torque to specification.
d
to
2)
2!
and nuts
and torque to
q
cables to their
Instr 9927473
Rev 01 2016-12
2#
3. Slide winch assembly
install onto the mounting bracket
holes and installing screws
the bracket as shown. Torque to specification.
4. Install the autostop fairlead
mounting bracket
to specification.
Page 6 of 13
TORQUE
4ft. lbs. (5.4 Nm)
t
from left to right and
d
by aligning
l
from the bottom of
TORQUE
20ft. lbs. (27.1 Nm)
s
to the fairlead
f
using two screws
h
. Torque