Printing A Demo Page; Changing The Display Language (Ml-3051N, Ml-3051Nd Only) - Samsung ML-3050 Manual

Network menu
This menu lets you configure the network interface installed in your
printer. You can reset the network interface and print a configuration
page.
Note
In the ML-3050 printer, this menu only appears when an
optional network printer server is installed.
(*: the default setting)
Item
TCP/IP
Values: DHCP*, BOOTP, Static
This item allows you to manually set the TCP/IP
addresses or receive the addresses from the
network.
• DHCP: The DHCP server allots the IP address to
you automatically.
• BOOTP: The BOOTP server allots the IP address
to you automatically.
• Static: You can enter IP address, subnet mask,
and gateway manually.
EtherTalk
Values: Off*, On
This item lets you select whether or not you use the
EtherTalk protocol. Select On to use the protocol.
NetWare
Values: Auto*, 802.2, 802.3, Ethernet II, SNAP, off
This item lets you select the IPX frame type.
• Auto: You can set the frame type automatically.
• 802.2: Select this value to use the IEEE 802.2
frame type.
• 802.3: Select this value to use the IEEE 802.3
frame type.
• Ethernet II: Select this value to use the Ethernet 2
frame type.
• SNAP: Select this value to use the SNAP frame
type.
• Off: You can disable the netware protocol.
Ethernet
Values: Auto*, 10M Half, 10M Full,
Speed
100M Half, 100M Full
This item allows you to select the ethernet speed.
Explanation
Item
Wireless
Values: SSID Type, Authentication, Encryption
Configure the wireless network environments.
See page 10.3.
Clear This item performs a simple reset and restores the
Setting factory default settings for the network configuration.
This setting will only take effect after you have reset
the printer.
Network This item print a page showing the network
Info parameters you set.

Printing a demo page

Print a demo page to make sure that the printer is operating correctly.
ML-3050, ML-3051N
Press and hold Demo for about 2 seconds.
ML-3051N, ML-3051ND
1 Press Menu and then OK when Information appears.
2 Press the Scroll buttons until Demo Page appears and press OK.
A demo page prints out.
Changing the display language
To change the language that is displayed on the control panel, follow
these steps:
1 Press Menu until System Setup appears on the bottom line of the
display and press OK.
2 Press OK when Language appears.
3 Press the Scroll buttons to select the language you want and press
OK.
4 Press Stop to return to Standby mode.
2.6
<System setup>
Explanation
Note
This menu only appears when an optional
wireless network interface card has been
installed.
(ML-3051N, ML-
3051ND only)