Bosch Professional GTM 12 JL Original Instructions Manual page 24

OBJ_BUCH-1688-007.book Page 39 Friday, February 24, 2017 12:15 PM
 Never operate the machine without the insert plate.
Replace a defective insert plate. Without flawless insert
plates, injuries are possible from the saw blade.
 Secure the workpiece. A workpiece clamped with clamp-
ing devices or in a vice is held more secure than by hand.
Safety Warnings for Use as a Table Saw
 Make sure that the guard operates properly and that it
can move freely. It must face against the table before saw-
ing and against the workpiece while sawing; never lock the
guard in place when opened.
 Never reach behind the saw blade in order to hold the
workpiece, remove saw dust/wood chips or for any oth-
er reason. The clearance of your hand to the rotating saw
blade is too small.
 Guide the workpiece against the saw blade only when
the machine is switched on. Otherwise there is damage
of kickback, when the saw blade becomes wedged in the
workpiece.
 Only saw one workpiece at a time. Workpieces placed on
top or aside of each other can cause the saw blade to jam
or the workpieces to move against each other while saw-
ing.
 Always use the parallel guide or the angle guide. This
improves the cutting accuracy and reduces the possibility
of saw blade binding.
 Products sold in GB only: Your product is fitted with a
BS 1363/A approved electric plug with internal fuse
(ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets, it should
be cut off and an appropriate plug fitted in its place by an
authorised customer service agent. The replacement plug
should have the same fuse rating as the original plug.
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains
socket elsewhere.
Products sold in AUS and NZ only: Use a residual current
device (RCD) with a rated residual current of 30 mA or
less.
Symbols
The following symbols can be important for the operation of
your power tool. Please memorise the symbols and their
meanings. The correct interpretation of the symbols helps
you operate the power tool better and more safely.
Symbol Meaning
 Laser Radiation
Do not stare into beam
Class 2 laser product
 Keep hands away from the cutting
area while the machine is running.
Danger of injury when coming in con-
tact with the saw blade.
Bosch Power Tools
Symbol Meaning
 Wear a dust respirator.
 Wear safety goggles.
 Wear ear protectors. Exposure to
 Danger area! Keep hands, fingers or
305mm
Ø max.
300mm
Ø min.
Observe the dimensions of the saw blade.
The hole diameter must match the tool
spindle without play. Do not use reducers
or adapters.
2 mm
51 mm
When changing the saw blade, pay atten-
tion that the kerf width is not less than
2,0 mm and the blade body thickness not
greater than 2,0 mm. Otherwise, there is
danger that the riving knife (2,0 mm) be-
comes wedged in the workpiece.
When operating the combination saw as a
table saw, the maximum workpiece height
is 51 mm.
Symbol on the lever 11 for tilting and lock-
ing the retracting blade guard
and
symbol on the tool arm release button 17
for releasing the tool arm.
Symbol for use of the combination saw as
a chop and mitre saw.
Symbol for use of the combination saw as
a table saw.
Autogoods "130"
English | 39
noise can cause hearing loss.
arms away from this area.
30mm
Ø
1 609 92A 5KX | (24.2.17)